IP Routing: RIP Configuration Guide, Cisco IOS Release 15M&T
Index
Downloads: The complete bookPDF (PDF - 2.59MB) | The complete bookePub (ePub - 245.0KB) | Feedback

Contents

A - C - E - F - I - M - O - R - S - T - U - V -

Index

A

adjusting IPv6 RIP timers, task 1
auto-summary (RIP) command 1

C

configuring the maximum numbers of equal-cost paths supported by IPv6 RIP, task 1

E

encapsulations
split horizon for Frame Relay and SMDS, RIP 1

F

Frame Relay, split horizonSMDS (Switched Multimegabit Data Service)
disabled split horizon 1

I

IP
advertising, definition 1
split horizon, enabling and disabling 1
ip rip authentication mode command 1
ip rip triggered command 1
ip split-horizon command 1
ip summary-address rip command 1
IPv6
prefix list operand keywords 1

M

MD5 (Message Digest 5) authentication
RIP 1
message URL http
//www.cisco.com/cisco/web/support/index.html 1
metrics
RIP 1

O

offset-list command 1
originating a default IPv6 RIP route, task 1

R

RIP (Routing Information Protocol)
IP
authentication 1
hop count 1
route summarization 1
source IP address, disabling validation of 1
version, specifying 1
RIP for IPv6
description 1 2
RIP router metric 1
route authentication
RIP 1
Routing Information Protocol (RIP)
IPv6
enabling 1

S

secondary addresses
use in Frame Relay and SMDS (example) 1
show ip rip database command 1
split horizon
enabling and disabling 1
summary addresses
entries, checking for 1

T

timers basic (RIP) command 1

U

UDP (User Datagram Protocol)
using with RIP 1

V

validate-update-source command 1