Guest

Cisco Unified Intelligent Contact Management Enterprise

How to Use the Kill Utility

Cisco - How to Use the Kill Utility

Document ID: 20431

Updated: May 17, 2006

   Print

Introduction

The Kill utility allows you to terminate a Cisco Intelligent Contact Management (ICM) process in a Telnet session. The termination occurs in the same way as a process termination with the use of Microsoft Windows NT Task Manager.

Note: For more information on Telnet, refer to Using Telnet to Run Utilities on Remote Cisco ICM Terminals.

Prerequisites

Requirements

There are no specific requirements for this document.

Components Used

This document is not restricted to specific software and hardware versions.

Conventions

Refer to Cisco Technical Tips Conventions for more information on document conventions.

Use the Kill Utility

In order to use the Kill utility, first determine which process you want to terminate. For more information on how to determine the process, refer to Using the pstat Command. For more information on the findstr command, refer to How to Use the findstr Command.

In this example, the opctest utility was not closed correctly:

48a.gif

The options available to use with the Kill utility are:

Option Definition
-f Forces process kill
pid The process ID of the process to kill, which the tlist (task list) command provides
pattern Complete task name or regular expression pattern to be matched against the task names and window titles

Related Information

Updated: May 17, 2006
Document ID: 20431