Guest

Cisco Small Business Voice Systems

Enabling Remote Management Feature on SPA9000

Document ID: 108817

Updated: Dec 12, 2008

   Print

Contents

Introduction
How to enable the remote management feature of SPA9000?
Related Information

Introduction


This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products.

Q. How to enable the remote management feature of SPA9000?

A.

To access the Web UI while the device is set to Bridge Mode, you will have to enable the WAN Web Server option with the default WAN Web Server Port set to 80. For instructions, complete these steps:

Enabling the Remote Management Feature

Step 1:
Access the SPA-9000 web-based setup page. For instructions, click here

Step 2:
Select Router and then click on Wan Setup.

Step 3:
Look for Enable WAN Web Server under Remote Management and select yes, then enter port "80" as the WAN Web Server Port.

Step 4:
Click on Apply all changes.

Related Information

Updated: Dec 12, 2008
Document ID: 108817