Guest

Cisco 12000 Series Routers

End-of-Sale and End-of-Life Announcement for the Cisco 12000 Series SPA Interface Processor-601, Performance Route Processor-3, and Associated Components

  • Viewing Options

  • PDF (205.7 KB)
  • Feedback

EOL9667

Cisco announces the end-of-sale and end-of-life dates for the Cisco 12000 Series SPA Interface Processor-601, Performance Route Processor-3, and Associated Components. The last day to order the affected product(s) is June 21, 2015. Customers with active service contracts will continue to receive support from the Cisco Technical Assistance Center (TAC) as shown in Table 1 of the EoL bulletin. Table 1 describes the end-of-life milestones, definitions, and dates for the affected product(s).Table 2 lists the product part numbers affected by this announcement. For customers with active and paid service and support contracts, support will be available under the terms and conditions of customers' service contract.

Table 1. End-of-Life Milestones and Dates for the Cisco 12000 Series SPA Interface Processor-601, Performance Route Processor-3, and Associated Components

Milestone

Definition

Date

End-of-Life Announcement Date

The date the document that announces the end-of-sale and end-of-life of a product is distributed to the general public.

March 21, 2014

End-of-Sale Date

The last date to order the product through Cisco point-of-sale mechanisms. Theproduct is no longer for sale after this date.

June 21, 2015

Last Ship Date:
HW

The last-possible ship date that can be requested of Cisco and/or its contract manufacturers. Actual ship date is dependent on lead time.

September 21, 2015

End of SW Maintenance Releases Date:
HW

The last date that Cisco Engineering may release any final software maintenance releases or bug fixes. After this date, Cisco Engineering will no longer develop, repair, maintain, or test the product software.

June 21, 2018

End of Routine Failure Analysis Date:
HW

The last-possible date a routine failure analysis may be performed to determine the cause of hardware product failure or defect.

June 21, 2016

End of New Service Attachment Date:
HW

For equipment and software that is not covered by a service-and-support contract, this is the last date to order a new service-and-support contract or add the equipment and/or software to an existing service-and-support contract.

June 21, 2016

End of Service Contract Renewal Date:
HW

The last date to extend or renew a service contract for the product.

September 21, 2019

Last Date of Support:
HW

The last date to receive applicable service and support for the product as entitled by active service contracts or by warranty terms and conditions. After this date, all support services for the product are unavailable, and the product becomes obsolete.

June 30, 2020

HW = Hardware OS SW = Operating System Software App. SW = Application Software

Table 2. Product Part Numbers Affected by This Announcement

End-of-Sale Product PartNumber

Product Description

Replacement Product Part Number

Replacement Product Description

Additional Information

12000-SIP-601

Multirate 10G IP Services Engines (Modular)

A9K-SIP-700

Cisco ASR 9000 Series SPA Interface Processor-700

-

12000-SIP-601-Y=

GSR SIP-601 with trusted sashimi licensing

A9K-SIP-700

Cisco ASR 9000 Series SPA Interface Processor-700

-

12000-SIP-601=

Multirate 10G IP Services Engine (Modular)

A9K-SIP-700

Cisco ASR 9000 Series SPA Interface Processor-700

-

FLASH-PRP3-2G

Cisco XR 12000 PRP-3 2GB Compact Flash

There is currently no replacement product available for this product.

-

-

FLASH-PRP3-2G=

Cisco XR 12000 PRP-3 2GB Compact Flash

There is currently no replacement product available for this product.

-

-

FLASH-PRP3-4G

Cisco XR 12000 PRP-3 4GB Compact Flash

There is currently no replacement product available for this product.

-

-

FLASH-PRP3-4G=

Cisco XR 12000 PRP-3 4GB Compact Flash

There is currently no replacement product available for this product.

-

-

HD-PRP3

Cisco 12000 PRP-3 80G Hard Drive

There is currently no replacement product available for this product.

-

-

HD-PRP3=

Cisco 12000 PRP-3 80G Hard Drive

There is currently no replacement product available for this product.

-

-

MEM-PRP3-4G

Cisco XR 12000 PRP-3 4GB Memory (2X2GB DIMM)

There is currently no replacement product available for this product.

-

-

MEM-PRP3-4G=

Cisco XR 12000 PRP-3 4GB Memory (2X2GB DIMM)

There is currently no replacement product available for this product.

-

-

MEM-PRP3-8G

Cisco XR 12000 PRP-3 8GB Memory - (2x4GB DIMM)

There is currently no replacement product available for this product.

-

-

MEM-PRP3-8G=

Cisco XR 12000 PRP-3 8GB Memory (2X4GB DIMM

There is currently no replacement product available for this product.

-

-

PRP-3

Cisco XR 12000 Performance Route Processor 3

There is currently no replacement product available for this product.

-

-

PRP-3=

Cisco XR 12000 Performance Route Processor 3

There is currently no replacement product available for this product.

-

-

PRP3-SMDC

PRP-3 Service Module Daughter Card

There is currently no replacement product available for this product.

-

-

PRP3-SMDC=

PRP-3 Service Module Daughter Card

There is currently no replacement product available for this product.

-

-

Product Migration Options

Customers are encouraged to migrate to the Cisco ASR 9010 or ASR 9922 Router. Information about this product can be found at: http://www.cisco.com/en/US/products/ps9853/index.html.

Customers may be able to use the Cisco Technology Migration Program (TMP) where applicable to trade-in eligible products and receive credit toward the purchase of new Cisco equipment. For more information about Cisco TMP, customers should work with their Cisco Partner or Cisco account team. Cisco Partners can find additional TMP information on Partner Central at http://www.cisco.com/web/partners/incentives_and_promotions/tmp.html.

Customers may be able to continue to purchase Cisco 12000 Series SPA Interface Processor-601, Performance Route Processor-3, and Associated Components through the Cisco Certified Refurbished Equipment program. Refurbished units may be available in limited supply for sale in certain countries on a first-come, first-served basis until the Last Date of Support has been reached. For information about the Cisco Certified Refurbished Equipment program, go to: http://www.cisco.com/go/eos.

Service prices for Cisco products are subject to change after the product End-of-Sale date.

The Cisco Takeback and Recycle program helps businesses dispose properly of surplus products that have reached their end of useful life. The program is open to all business users of Cisco equipment and its associated brands and subsidiaries. For more information, go to: http://www.cisco.com/web/about/ac227/ac228/ac231/about_cisco_takeback_recycling.html.

For More Information

For more information about the Cisco ASR 9010 or ASR 9922 Router, visit http://www.cisco.com/en/US/products/ps9853/index.html, or contact your local account representative.

For more information about the Cisco End-of-Life Policy, go to: http://www.cisco.com/en/US/products/products_end-of-life_policy.html.

For more information about the Cisco Product Warranties, go to: http://www.cisco.com/en/US/products/prod_warranties_listing.html.

To subscribe to receive end-of-life/end-of-sale information, go to: http://www.cisco.com/cisco/support/notifications.html.

Subscribe for RSS Notifications for End-of-Life and End-of-Sale Notices

To subscribe to the End-of-Life and End-of-Sale RSS Feed, insert the following URL into your RSS application: http://www.cisco.com/web/feeds/products/end_of_life_rss.xml.

Any authorized translation issued by Cisco Systems or affiliates of this end-of-life Product Bulletin is intended to help customers understand the content described in the English version. This translation is the result of a commercially reasonable effort; however, if there are discrepancies between the English version and the translated document, please refer to the English version, which is considered authoritative.