|
The Network Diagnostics screen contains the diagnostic tests that
can be run.
Settings
Radio Diagnostics Tests
Clicking on this link takes you to the
Radio Diagnostics screen where you can choose to implement an
antenna alignment test or conduct a carrier test. The carrier test
helps you determine which radio frequencies contain the most radio
activity and noise that could interfere with radio signals to and
from the access point.
Note The access point performs
the carrier test for the internal radio only; it does not perform
the carrier test for the radio module.
Use the carrier test to determine the best frequency for the access
point to use. When you conduct a carrier test, make sure all wireless
networking devices within range of the access point are operating
to make the test results reflect a realistic radio environment.
When you click Start, the radio scans
the access point’s available frequencies and displays the radio
activity in the Carrier Test window.
Note The access point drops
all associations with wireless networking devices during the carrier
test.
VLAN Summary Status
Clicking on this link takes you to the VLAN
Summary Status page where you can see a list of the VLANs created
on the access point.
The following links are available on VLAN Summary Status page:
- VLAN Detailed Setup -- Takes you to
the VLAN Setup page, from which you can add, remove, or edit your
VLAN configuration.
- ID(#) -- Takes you to the VLAN Setup
page for the VLAN ID selected where you can edit the configuration.
- Def. Pol. Grp (if set) -- Takes you
to the Policy Groups page, where you can edit the configuration.
Service Sets
Clicking on this link takes you to the AP
Radio Service Set Summary Status page where you can see the
status of service sets.
SSIDs: Int, Mod
Clicking this link takes you to the AP
Radio Internal Service Set Summary Status page for your access
point and shows a typical SSID summary status page for the module
radio.
The following links are available on the SSIDs: Int, Mod page:
- Service Set Detailed Setup -- Takes
you to the AP Radio Module Service Sets page, from which you can
create, remove, or edit your SSID configuration.
- Idx(#) -- Takes you to the AP Radio
Primary SSID page of the number selected where you can edit its
configuration.
|
