Configuring Logging Settings

To configure logging:

  1. Choose Administration > Logging > Log Settings.
  2. In the Log Mode field, check the Enable check box.
  3. Click Add Row.
  4. Configure the following settings:

    Log Server

    Enter the IP address of the log server that will collect logs.

    Log Priority

    Choose the events to log from the drop-down menu. The event severity levels are listed from the highest severity to the lowest severity, as follows:

    All--Log all events.

    Emergency--System is not usable.

    Alert--Action is needed.

    Critical--System is in a critical condition.

    Error--System is in error condition.

    Warning--System warning occurred.

    Notification--System is functioning properly, but a system notice occurred.

    Informational--Device information.

    Debugging--Provides detailed information about an event.

    Display in Event Log

    To display log messages in the event log, check this check box.

    All log messages appear in the Device Manager in the View Logs page (Status > View Logs).

    Send to Email

    To send logs to a configured email address (see Configuring E-Mailing of Logs), check this check box.

    Enable

    To enable these logging settings, check this check box.

  5. Click Save.

To edit an entry in the Logging Setting Table, select the entry and click Edit. Make your changes, then click Save.