QoS Interface Settings

The Interface Settings page enables configuring QoS on each port of the device, as follows:

  • QoS State Disabled on an Interface—All inbound traffic on the port is mapped to the best effort queue and no classification/prioritization takes place.

  • QoS State of the Port is Enabled—Port prioritize traffic on ingress is based on the system-wide configured trusted mode, which is either CoS/802.1p trusted mode or DSCP trusted mode.

To enter QoS settings per interface, complete the following steps:

Procedure

Step 1

Click Quality of Service > QoS Basic Mode > Interface Settings.

Step 2

Use the filter to select the Interface Type (Port or Lag) and click Go to display the current settings. QoS State displays whether QoS is enabled on the interface

Step 3

Select an interface, and click Edit.

Step 4

Select the Port or LAG interface.

Step 5

Click to enable or disable QoS State for this interface.

Step 6

Click Apply. The Running Configuration file is updated.