|
Server Definition
|
Select whether to identify the remote log server by IP address or name.
|
|
IP Version
|
Select the supported IP format.
|
|
IPv6 Address Type
|
Select the IPv6 address type (if IPv6 is used). The options are:
-
Link Local—The IPv6 address uniquely identifies hosts on a single network link. A link local address has a prefix of FE80::/10, isn’t routable, and can be used for communication only on the local network. Only one link local address is supported. If a link local address exists on the interface, this entry replaces the address in the configuration.
-
Global—The IPv6 address is a global Unicast IPV6 type that is visible and reachable from other networks.
|
|
Link Local Interface
|
Select the link local interface (if IPv6 Address Type Link Local is selected) from the list.
|
|
Log Server IP Address/Name
|
Enter the IP address or domain name of the log server.
|
|
UDP Port
|
Enter the UDP port to which the log messages are sent.
|
|
Facility
|
Select a facility value from which system logs are sent to the remote server. Only one facility value can be assigned to a server. If a second facility code is assigned, the first facility value is overridden.
|
|
Description
|
Enter a server description.
|
|
Minimum Severity
|
Select the minimum level of system log messages to be sent to the server.
|