Neighbor Binding Table

Step 1

Click Security > IPv6 First Hop Security > Neighbor Binding Table

Step 2

Select one of the following clear table options:

• None- Clears none.

• Static Only—Clear all static entries in the table.

• Dynamic Only—Clear all dynamic entries in the table.

• All Dynamic & Static—Clear all dynamic and static entries in the table.

  The following fields are displayed for each policy (only fields not on Add page are displayed:

• Origin—Protocol that added the IPv6 address (only available for dynamic entries):

  • Static—Added manually.

  • NDP—Learnt from Neighbor Discovery Protocol messages.

  • DHCP—Learnt from DHCPv6 protocol messages.

• State—State of the entry:

  • Tentative—The new host IPv6 address is under validation. Since its lifetime is less than 1 sec its expiration time is not displayed.

  • Valid—The host IPv6 address was bound.

• Expiry Time (Sec.)—Remaining time in seconds until the entry will be removed, if it is not confirmed.

• TCAM Overflow—Entries marked as No have not been added to the TCAM because TCAM overflow.

Step 3

To add a policy, click Add and enter the following fields:

• VLAN ID—VLAN ID of the entry.

• IPv6 Address—Source IPv6 address of the entry.

• Interface—Port or LAG on which a packet is received.

• MAC Address—Neighbor MAC address of the packet.

Step 4

Click Apply to add the settings to the Running Configuration file.