Layer 3 Switching
A layer 3 switch combines a switch's and a router's capabilities. It has IP routing intelligence built into it to double as a router and acts as a switch to quickly link devices that are on the same subnet or virtual LAN. Incoming packets can be inspected, routing decisions can be made depending on source and destination addresses, and it can handle routing protocols. A layer 3 switch functions as both a switch and a router in this manner:
To setup your device as a layer 3 switch, follow these steps:
Procedure
Step 1 | Click VLAN Management > VLAN Settings. |
Step 2 | Click Add. |
Step 3 | Enter the VLAN ID and VLAN Name. |
Step 4 | Click Apply to create the VLAN. |
Step 5 | Next, navigate to IPv4 Configuration >IPv4 Interface. |
Step 6 | Check Enable to enable IPv4 Routing. This will allow routing among all Layer 3 Interfaces and will allow traffic from one VLAN to be forwarded to another VLAN. |
Step 7 | Click Apply to enable routing among all Layer 3 interfaces. This will allow traffic from one VLAN to be forwarded to another VLAN. |