ASV Interface Settings

The user activates the auto surveillance feature on selected interfaces. The feature can be activated on ports or LAGs. When surveillance traffic is detected on an interface with ASV enabled, this traffic is routed to the ASV.

To configure the ASV interface settings, follow these steps:

Procedure

Step 1

Click VLAN Management >Auto-Surveillance VLAN > ASV Interface Settings.

Step 2

Select the interface type Port or LAG and click Go.

Step 3

To edit an ASV interface setting click Edit.

Step 4

Next, select the interface (Port or LAG).

Step 5

Check Enable to enable auto surveillance VLAN membership.

Step 6

Click Apply to save the settings.