Table Of Contents
Cable and Power Cord Specifications
Supported Power Cords and Plugs
Cable and Power Cord Specifications
This appendix provides cabling and port specifications for control devices and power connections and includes the following sections:
•
Supported Power Cords and Plugs
KVM Cable
The KVM cable provides a connection into the server, providing a DB9 serial connector, a VGA connector for a monitor, and dual USB ports for a keyboard and mouse. With this cable, you can create a direct connection to the operating system and the BIOS running on the server.
This server supports the following Cisco components and part numbers.
Figure B-1 KVM Cable
Connector to server
DB9 serial connector
VGA connection for a monitor
Two-port USB connector for a mouse and keyboard
Supported Power Cords and Plugs
Each power supply has a separate power cord. Standard power cords or jumper power cords are available for connection to a power distribution unit that has IEC 60320 C19 outlet receptacles. The jumper power cords, for use in racks, are available as an optional alternative to the standard power cords. For more information, contact Cisco technical support.
The standard power cords have an IEC C19 connector on the end that plugs into the Power Distribution Unit (PDU), which is located in the bottom slot at the rear of the chassis. The optional jumper power cords have an IEC C19 connector on the end that plugs into the chassis' PDU and an IEC C20 connector on the end that plugs into an IEC C19 outlet receptacle.
Note
Table B-1 lists the power cords for the server power supplies.
