There are no specific requirements for this document.
Cisco ASA 5500和ASA5500-X 9.1(2)及以后
Cisco ASDM 7.1及以后
The information in this document was created from the devices in a specific lab environment.All of the devices used in this document started with a cleared (default) configuration.If your network is live, make sure that you understand the potential impact of any command.
ASA#copy tftp [[flash:/disk0:][software image name/asdm image name]]
!--- Command to set an image as bootup or specify the !--- ASDM image file.
ASA(config)#boot system [flash:/disk0:]/[software image name]
!--- Save active configuration to the Flash.
!--- Reboot the security appliance and load !--- with the new boot image as per the configuration file.
4118732800 bytes total (3556712448 bytes free)
!--- Command to set "asa916-smp-k8.bin" as the boot image.
ASA-5512(config)# boot system disk0:/asa916-smp-k8.bin
!--- Command to set "asdm-741.bin" as the ASDM image.
ASA-5512(config)# asdm image disk0:/asdm-741.bin
ASA-5512# write memory