QA Test Sprint 9 CSCta77961: Test that each Command appears in its own page.
karthik has inserted part of sprint6-round1 build
karthik added this to check wan bridge issue in sprint12
To create a VNIC (Virtual Network Interface Card), use the create vnic command.
create vnic name { fabric { a | a-b | b | b-a } | eth-if eth-if } *
name |
VNIC template name. The range of valid values is 1 to 16. |
fabric |
Specifies the fabric switch identification number. |
a |
Specifies switch A. |
a-b |
Specifies redundant, with switch A as primary. |
b |
Specifies switch B. |
b-a |
Specifies redundant, with switch B as primary. |
eth-if |
Specifies a Ethernet interface. |
eth-if |
Ethernet interface name. The range of valid values is 1 to 16. |
None
Service profile (/org/service-profile)
Release | Modification |
---|---|
1.0(1) |
This command was introduced. |
Use this command to create a vNIC with the specified name, and enters organization virtual NIC mode.
This example shows how to create a vNIC:
switch-A# scope org org3 switch-A /org # scope service-profile sp1 switch-A /org/service-profile # create vnic vnic110 switch-A /org/service-profile/vnic* # commit-buffer switch-A /org/service-profile/vnic #
QA Test: CSCtd06182 Check that the shortdescriptions appear on the dfescription column below. Also click on the first cross chapter link and see that it works in html and pdf chapters
Command | Description |
This is short description for vsan command | |
This is short dfescription for create vnic-egress-policy command |