t_config_wlans_mob_anch

Available Languages

Updated:November 29, 2020

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Configuring a Mobility Anchor for a WLAN/RLAN

Configuring a Mobility Anchor for a WLAN/RLAN

Mobility Anchor, also referred to as Guest tunneling or Auto Anchor Mobility allows you tunnel all client traffic that belongs to a WLAN (Specially Guest WLAN) to a predefined device that is configured as Anchor for that specific WLAN. Associate a mobility anchor to your WLAN, to restrict clients to a specific subnet and to ensure more control over user traffic.

To associate your WLAN/RLAN to a mobility anchor:

Note: If the selected WLAN/RLAN is in Enabled state, updating WLAN details may result in loss of connectivity.

  1. On the Configure > WLANs page, select the WLAN/RLAN in the Wireless Networks section, and click Mobility Anchor.
  2. In the Wireless Network Details section, choose a device from the Switch IP Address drop-down list.
  3. Click Apply.

 

© 2020 Cisco Systems, Inc. All rights reserved.

 

Was this Document Helpful?

FeedbackFeedback

Contact Cisco