The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
Parameters
Parameters
On the Configuration > Radio Configurations > Parameters page, you can configure global parameters for 802.11a/n/ac (5 GHz) and 802.11b/g/n (2.4 GHz) radios.
Note: You cannot configure or modify parameters if the radio network is enabled. Disable the network status on the Configuration > Radio Configurations > Network page before you proceed.
In the EDCA Parameters section, choose an EDCA profile from the In theEDCA Profile drop-down list. Enhanced distributed channel access (EDCA) parameters are designed to provide preferential wireless channel access for voice, video, and other quality-of-service (QoS) traffic.
For 802.11a/n/ac (5 GHz) radios, in the DFS (802.11h) section, enter the local power constraint. You cannot configure power constraint if the DPTC Support check box on the Configuration > Radio Configurations > Network page is checked. The valid range is between 0 dBm and 30 dBm.
From the Channel Switch Announcement Mode drop-down list, select either the Loud or Quiet mode.
Enable or disable Smart DFS. It is enabled by default.
In the 11ax Parameters section, enable or disable the following as per your requirement:
Target Wakeup Time
Target Wakeup Time Broadcast
Multiple Bssid
Enable BSS color globally for the 5 GHz and 2.4 GHz radios by checking the BSS Color check box.
From the BSS Color Assignment Mode drop-down list, select either Automatic or Off mode. The BSS Color Assignment Leader is displayed. If you select the Automatic mode, the Last Run BSS color assignment is displayed.