1. In the General section, check the Ethernet Bridging Allow BPDU check box to enable ethernet bridging for mesh.
2. Check the Subset Channel Sync check box to synchronize subset channel.
3. In the Backhaul section, check the Extended UNII B Domain Channels check box to enable this feature.
4. Check the RRM check box to enable RRM.
5. In the Security section, check the PSK Provisioning check box to provision PSK.
6. Check the Default PSK check box to enable PSK.

7. In the Alarm section and Max Hop Count field, enter the maximum hop count between 1 and 16.

8. In the Recommended Max Children for MAP field, enter the maximum children for MAP between 1 and 50.

9. In the Recommended Max Children for RAP field, enter the maximum children for RAP between 1 and 50.
10. In the Parent Change Count field, enter the parent change count between 1 and 30.
11. In the Low Link SNR field, enter the low link SNR between 1 and 30 dB.
12. In the High Link SNR field, enter the high link SNR between 31 and 100 dB.
13. In the Association Count field, enter the count between 1 and 30.
14. Click Apply.

In the Profiles tab, click Add to configure the following:

General

1. In the Add Mesh Profile window, click the General tab.

2. Enter a name and description for the mesh profile.

3. Specify the Range (Root AP to Mesh AP). The valid range is between 150 and 132000.

4. From the Multicast Mode drop-down list, choose one of the following options:

   • Regular

   • In

   • In-Out

5. Check the IDS (Rogue/Signature Detection) check box to enable IDS.

6. From the Convergence Method drop-down list, choose one of the following options:

   • Fast

   • Noise Tolerant Fast

   • Standard

   • Very Fast

7. Check the Background Scanning check box to enable background scanning.
8. Check the Channel Change Notification check box to notify channel change.
9. Check the LSC check box to enable locally significant certificates (LSC).

10. Check the Backhaul amsdu check box to enable backhaul amsdu.

11. Check the Backhaul Client Access check box to enable this feature.
12. Check the Battery State for an AP check box to identify the battery state of an access point.
13. Check the Full sector DFS Status check box to enable DFS status of a full sector.
14. Click Apply to Device.

Advanced

1. In the Add Mesh Profile window, click the Advanced tab.
2. In the Security section, choose one of the following options from the Method drop-down:

   • EAP

   • PSK

3. From the Authentication Method drop-down, enter a method or choose the default.

4. From the Authorization Method drop-down, enter a method or choose the default.

5. In the Ethernet Bridging section, check the VLAN Transparent check box to enable this feature.

6. Check the Ethernet Bridging check box to enable ethernet bridging.

7. In the Bridge Group section, enter a bridge group name.
8. Check the Strict Match check box to enable this feature.
9. Select the Backhaul rate types using the drop-downs from 5 GHz Band Backhaul and 2.4 GHz Band Backhaul.
10. Click Apply to Device.