Contents
Monitoring the Cisco uBR-MC3GX60V-RPHY Line Card
Verifying the Cisco uBR-MC3GX60V-RPHY Line Card Installation Using LEDs
Verify the following LEDs on the Cisco uBR-MC3GX60V-RPHY line card to check if it is operational.
Table 1 LEDs on the Cisco uBR-MC3GX60V-RPHY Line Card LED
Status
Description
POWER
Off
The Cisco uBR-MC3GX60V-RPHY line card is not powered on.
Green
The Cisco uBR-MC3GX60V-RPHY line card is not powered on.
STATUS
Off
The Cisco uBR-MC3GX60V-RPHY line card is powered on.
Green
The processor on the Cisco uBR-MC3GX60V-RPHY line card has booted and passed the diagnostics, or is in the standby mode.
Yellow
The Cisco uBR-MC3GX60V-RPHY line card is in bootup mode.
MAINT
Off
No action is required.
Yellow
It is safe to remove the Cisco uBR-MC3GX60V-RPHY line card.
GE0 and GE1
Off
The DEPI port is not enabled.
Green
The DEPI port is configured and is able to send traffic.
LK/ACT0-LK/ACT5
Off
The Ethernet link is not working.
Green (steady)
The Gigabit Ethernet port is enabled and the Ethernet link is working, and there is no US or DS traffic flow.
Green (blinking)
The Gigabit Ethernet port is enabled and the Ethernet link is working, and there is US or DS traffic flow.
Verifying the Cisco uBR-MC3GX60V-RPHY Line Card Using the CLI
Verify the Cisco uBR-MC3GX60V-RPHY line card using the following commands:
Table 2 Commands Used to Verify the Cisco uBR-MC3GX60V-RPHY Line Card Command
Purpose
Displays the MAC domain information to verify the bonding operation on the Cisco uBR-MC3GX60V-RPHY line card.
Displays the software license of the Cisco uBR-MC3GX60V-RPHY line card.
show controller modular-cable Displays the Cisco uBR-MC3GX60V-RPHY line card Statistics.
This command allows the user to view the following line card statistics:
Displays the interface controllers information on the Cisco uBR-MC3GX60V-RPHY line card.
show cable modem Displays the Cable modem information.
show cable clock Displays the DOCSIS Timing and Control Card (DTCC) and its current status.
show controllers modular-cable sfp Displays information about the SFP modules on the Cisco uBR-MC3GX60V-RPHY line card.
If the SFP module is not present, the following output is displayed:SFP in Port1 is NOT PRESENTshow ip interfaces brief Displays the bidirectional communication between the Cisco CMTS and the Cisco CMC.
The Cisco uBR-MC3GX60V-RPHY line card has three Gigabit Ethernet interfaces. When an IP address is configured on the Gigabit Ethernet interface in a subnet that includes the Cisco CMC, the IP address of the Cisco CMC becomes pingable.
show diag Displays the hardware and diagnostic information of the Cisco uBR-MC3GX60V-RPHY line card.
Notices
Copyright © 2014, Cisco Systems, Inc. All rights reserved.