Reboot and Reset Factory Default Settings on the WAP351

Available Languages

Download Options

PDF (84.5 KB)
View with Adobe Reader on a variety of devices
ePub (116.3 KB)
View in various apps on iPhone, iPad, Android, Sony Reader, or Windows Phone
Mobi (Kindle) (216.1 KB)
View on Kindle device or Kindle app on multiple devices

Updated:November 29, 2018

Document ID:SMB5086

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Reboot and Reset Factory Default Settings on the WAP351

Objective

Rebooting a device is used to shut down and restart the device with a saved configuration. The factory default is used to restore the factory default configuration on the device to remove any previous configurations.

The objective of this document is to show you how to reboot your WAP351 device and reset it to the factory default.

Applicable Devices

• WAP351

Software Version

• 1.0.0.39

Reset to Factory Default

There are two ways to reset the Access Point to the factory default configuration:

• Hardware reset

• Reset with the use of the web configuration utility

Hardware Reset

Step 1. Press and hold the Reset button located at the back of the device for approximately ten seconds with a pin.

The Access Point reloads and is set to the default configuration settings.

Step 2. Login with the default credentials. The default username is cisco, and the default password is cisco.

Reset with the use of the Web Configuration Utility

Step 1. Log into the web configuration utility page and choose Administration > Reboot. The Reboot page opens:

Step 2. To reset the device, click the Reboot To Factory Default button.

A Confirm page appears:

Step 3. Click OK.

A Progress Bar appears:

Step 4. After the reboot is completed, login with the default credentials. The default username is cisco, and the default password is cisco.

Rebooting the Device

There are two ways to reboot the Access Point:

• Hardware reboot

• Reboot with the use of the web configuration utility

Hardware Reboot

Step 1. Press the Power button to turn off the device. After 10 seconds have passed, press the Power button a second time to power the device back on.