1. Click VPN > Site-to-Site > IPsec Policies.
The IPsec Policies window opens. All existing IPsec VPN policies are listed in the table. The following information is displayed:
• Name: The name of the IPsec VPN policy.
• Enable: Shows if the IPsec VPN policy is enabled or disabled.
• Status: Shows if the IPsec VPN tunnel is connected or disconnected.
• WAN Interface: The WAN port that traffic passes through over the IPsec VPN tunnel.
• Peers: The IP address of the remote peer.
• Local: The local network of the local peer.
• Remote: The remote network of the remote peer.
• IKE: The IKE policy used for the IPsec VPN policy.
• Transform: The transform set used for the IPsec VPN policy.
2. Click On to enable site-to-site VPN, or click Off to disable it.
NOTE: Enabling the Site-to-Site VPN feature will disable the Teleworker VPN Client feature.
3. If you enable site-to-site VPN, perform the following actions:
• To add a new IPsec VPN policy, click Add. See Configuring IPsec VPN Policies.
• To edit an existing IPsec VPN policy, click the Edit (x) icon.
• To delete an IPsec VPN policy, click the Delete (x) icon.
• To delete multiple IPsec VPN policies, check them and click Delete.
• To enable an IPsec VPN policy, check the box in the Enable column.
• To manually establish a VPN tunnel, click the Connect icon for an enabled IPsec VPN policy.
• To manually terminate a VPN connection, click the Disconnect icon.
• To refresh the data for site-to-site VPN, click Refresh.