Access Points
Single Point Setup allows WAP561-A-K9 access points to propagate settings.

Single Point Setup: Enabled
Access Points detected in Cluster: CiscoEmulator
Location MAC Address IP Address Cluster-Priority Cluster-Controller  
CiscoEmulLab1 68:86:A7:FE:75:C0 192.168.20.25 2 no
CiscoEmulLab2 64:AE:0C:F0:AB:E0 192.168.20.57 1 no
CiscoEmulLab3 68:86:A7:FE:7C:A0 192.168.20.24 10 yes
CiscoEmulLab4 00:11:22:33:44:80 192.168.20.26 2 no
CiscoEmulLab5 7C:69:F6:34:D0:30 192.168.20.27 2 no
CiscoEmulLab6 5E:11:45:F1:D1:C0 192.168.20.28 3 no
CiscoEmulLab7 00:11:0E:33:55:E0 192.168.20.29 4 no
CiscoEmulLab8 55:F4:1E:24:23:80 192.168.20.30 5 no
CiscoEmulLab9 30:A1:0E:33:55:50 192.168.20.32 6 no
CiscoEmulLab10 50:B1:23:34:55:C0 192.168.20.33 7 no
CiscoEmulLab11 68:86:A7:FE:7A:A0 192.168.20.34 8 no
 
To change your clustering options, click "Disable Single Point Setup".
Enter the location of this AP.
Location: (Range: 1-64 Characters)
 
Enter the name of the cluster for this AP to join.
Cluster Name: (Range: 1-64 Characters)
Clustering IP Version: IPv6 IPv4
Cluster-Priority: (Range: 0-255, Default: 0)
Clustered
3 Access Points

Disable Single Point Setup

Single IP Management
Cluster Management Address: (X.X.X.X)