Configuration Server
Protocol
Set this parameter to match the network's method
of IP address assignments. Choose DHCP if your network servers
are using automatic assignment of IP addresses. Choose Static
IP if fixed IP addresses are being assigned. Choose Disable
DHCP Address Binding if you require compatibility with older
DHCP servers. Normally, you would not check this check box. If you
check the check box, no client identifier is sent to the DHCP server.
The client identifier is used by the DHCP server to issue consistent
IP addresses.
Note: Proxy Mobile IP does not interfere
with clients that have DHCP. However, if you want to use proxy Mobile
IP with DHCP-enabled clients, you must disable media sense on the
client. Proxy Mobile IP works only if static IP address is enabled
on mobile node or DHCP IP addresses on the mobile node have media
sense disabled.
IP Address
Use this setting to assign or change the access
point's IP address. If DHCP is not enabled for your network, the
IP address you enter in this field is the access point's IP address.
If DHCP is enabled, you cannot modify this field.
IP Subnet Mask
Enter an IP subnet mask to identify the subnetwork
so the IP address can be recognized on the LAN. If DHCP is not enabled,
this field is the subnet mask. If DHCP is enabled, you cannot modify
this field.
Default Gateway IP Address
Enter the IP address of the network's default gateway.
If DHCP is enabled, you cannot modify this field.
|