Voice monitoring and recording are features of the IP Integrated Contact Distribution (ICD) Cisco Supervisor Desktop client. These features allow a supervisor to silently monitor and record the phone call of an agent. This document describes the reason that monitoring and recording of IP calls on two different Cisco Catalyst 6509 switches fails with distorted voice in a Cisco IP Contact Center (IPCC) environment.
Readers of this document should be knowledgeable of the following:
Cisco IPCC Express
Cisco Catalyst 6509 configuration
The information in this document is based on the software versions:
All Cisco CallManager versions
All Cisco IPCC Express versions
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
For more information on document conventions, refer to the Cisco Technical Tips Conventions.
When the monitoring and recording failure occurs, the topology is set up, as shown in Figure 1.Figure 1: Topology
When performing voice monitoring and recording between two agents on the same Catalyst 6509 switch, the voice playback is normal. However, when performing voice monitoring and recording between two agents on different Catalyst 6509 switches, the voice playback is slow and slightly distorted.
This problem is a Catalyst 6509 Remote Switched Port Analyzer (RSPAN) configuration issue. When configuring RSPAN, the original RSPAN setup is VLAN RSPAN. Since trunk port is part of the VLAN, it also monitors and records all traffic over the trunking port. This creates a packet duplication problem in the process of voice monitoring and recording.
To fix the duplicate-packet problem, change the RSPAN configuration from VLAN RSPAN to port RSPAN. Ports for CallManager, IPCC Express servers and agents (except trunking ports) should be configured with port SPAN. When configuring the port, configure either transit (Tx) or receive (Rx), but not both.
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.