Table Of Contents
Disable Novell IPX/NLSP/SAP
Finding Feature Information
Contents
Information About Disable Novell IPX/NLSP/SAP
Removal of Support for IPX Routing
Removal of Support for Novell IPX Commands
Additional References
Related Documents
Standards
MIBs
RFCs
Technical Assistance
Feature Information for Disable Novell IPX/NLSP/SAP
Disable Novell IPX/NLSP/SAP
First Published: July 8, 2011
Last Updated: October 15, 2012
Support for Novell Internetwork Packet Exchange (IPX) routing using NetWare Link Services Protocol (NLSP), Service Advertising Protocol (SAP), Enhanced Interior Gateway Routing Protocol (EIGRP), and Routing Information Protocol (RIP), related features, and commands has been removed from Cisco IOS Release 15.1(3)S, 15.2(2)T, 15.1(1)SY, and later releases.
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest feature information and caveats, see the release notes for your platform and software release. To find information about the features documented in this module, and to see a list of the releases in which each feature is supported, see the "Feature Information for Disable Novell IPX/NLSP/SAP" section.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support. To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not required.
Contents
•
Information About Disable Novell IPX/NLSP/SAP
•Additional References
•Feature Information for Disable Novell IPX/NLSP/SAP
Information About Disable Novell IPX/NLSP/SAP
•Removal of Support for IPX Routing
•Removal of Support for Novell IPX Commands
Removal of Support for IPX Routing
The Novell Internetwork Packet Exchange (IPX) is a routed protocol that is derived from the Xerox Network Systems (XNS) Internet Datagram Protocol (IDP). Cisco supports IPX routing using the EIGRP/RIP protocol.
Because of a significant decrease in the usage of and demand for the Novell IPX protocol, Cisco has decided to discontinue support for IPX routed protocols EIGRP and RIP.
The Novell IPX routed protocol is not supported in Cisco IOS release 15.1(3)S and later releases.
Removal of Support for Novell IPX Commands
The following commands are obsolete and are no longer supported in Cisco IOS Releases 15.1(3)S and later releases (no replacement commands are provided):
•access-list (IPX extended)
•access-list (IPX standard)
•access-list (NLSP)
•access-list (SAP filtering)
•area-address (NLSP)
•clear ipx accounting
•clear ipx cache
•clear ipx nhrp
•clear ipx nlsp neighbors
•clear ipx route
•clear ipx sap
•clear ipx traffic
•debug ipx
•deny (extended)
•deny (NLSP)
•deny (SAP filtering)
•deny (standard)
•distribute-list in
•distribute-list out
•distribute-sap-list in
•distribute-sap-list out
•ipx access-group
•ipx access-list
•ipx accounting
•ipx accounting-list
•ipx accounting-threshold
•ipx accounting-transits
•ipx advertise-default-route-only (RIP)
•ipx advertise-to-lost-route
•ipx backup-server-query-interval (EIGRP)
•ipx bandwidth-percent eigrp
•ipx broadcast-fastswitching
•ipx compression cipx
•ipx default-output-rip-delay
•ipx default-output-sap-delay
•ipx default-route
•ipx default-triggered-rip-delay
•ipx default-triggered-rip-holddown
•ipx default-triggered-sap-delay
•ipx default-triggered-sap-holddown
•ipx delay
•ipx down
•ipx eigrp-redistribution-bandwidth
•ipx eigrp-sap-split-horizon
•ipx encapsulation
•ipx flooding-unthrottled (NLSP)
•ipx gns-reply-disable
•ipx gns-response-delay
•ipx gns-round-robin
•ipx hello-interval eigrp
•ipx helper-address
•ipx helper-list
•ipx hold-down eigrp
•ipx hold-time eigrp
•ipx input-network-filter (RIP)
•ipx input-sap-filter
•ipx internal-network
•ipx ipxwan
•ipx ipxwan error
•ipx ipxwan static
•ipx link-delay
•ipx linkup-request (RIP)
•ipx maximum-hops (RIP)
•ipx maximum-paths
•ipx nasi-server enable
•ipx netbios input-access-filter
•ipx netbios output-access-filter
•ipx netbios-socket-input-checks
•ipx network
•ipx nhrp authentication
•ipx nhrp holdtime
•ipx nhrp interest
•ipx nhrp map
•ipx nhrp max-send
•ipx nhrp network-id
•ipx nhrp nhs
•ipx nhrp record
•ipx nhrp responder
•ipx nhrp use
•ipx nlsp csnp-interval
•ipx nlsp enable
•ipx nlsp hello-interval
•ipx nlsp hello-multiplier
•ipx nlsp lsp-interval
•ipx nlsp metric
•ipx nlsp multicast
•ipx nlsp priority
•ipx nlsp retransmit-interval
•ipx nlsp rip
•ipx nlsp sap
•ipx output-ggs-filter
•ipx output-gns-filter
•ipx output-network-filter (RIP)
•ipx output-rip-delay
•ipx output-sap-delay
•ipx output-sap-filter
•ipx pad-process-switched-packets
•ipx per-host-load-share
•ipx ping-default
•ipx potential-pseudonode (NLSP)
•ipx rip-max-packetsize
•ipx rip-multiplier
•ipx rip-queue-maximum
•ipx rip-response-delay
•ipx rip-update-queue-maximum
•ipx route
•ipx route-cache
•ipx route-cache inactivity-timeout
•ipx route-cache max-size
•ipx route-cache update-timeout
•ipx router
•ipx router-filter
•ipx router-sap-filter
•ipx routing
•ipx sap
•ipx sap follow-route-path
•ipx sap-helper
•ipx sap-incremental (EIGRP)
•ipx sap-incremental split-horizon
•ipx sap-max-packetsize
•ipx sap-multiplier
•ipx sap-queue-maximum
•ipx sap-update-queue-maximum
•ipx server-split-horizon-on-server-paths
•ipx split-horizon eigrp
•ipx spx-idle-time
•ipx spx-spoof
•ipx throughput
•ipx triggered-rip-delay
•ipx triggered-rip-holddown
•ipx triggered-sap-delay
•ipx triggered-sap-holddown
•ipx type-20-helpered
•ipx type-20-input-checks
•ipx type-20-output-checks
•ipx type-20-propagation
•ipx update interval
•ipx update sap-after-rip
•ipx watchdog
•ipx watchdog-spoof
•log-adjacency-changes (IPX)
•log-neighbor-changes (EIGRP)
•log-neighbor-warnings
•lsp-gen-interval (IPX)
•lsp-mtu (IPX)
•lsp-refresh-interval (IPX)
•max-lsp-lifetime (IPX)
•multicast
•nasi authentication
•netbios access-list (IPX)
•network (IPX Enhanced IGRP)
•permit (IPX extended)
•permit (IPX standard)
•permit (NLSP)
•permit (SAP filtering)
•ping ipx
•prc-interval (IPX)
•priority-list (global)
•redistribute (IPX)
•route-aggregation (NLSP)
•show ipx access-list
•show ipx accounting
•show ipx cache
•show ipx eigrp interfaces
•show ipx eigrp neighbors
•show ipx eigrp topology
•show ipx eigrp traffic
•show ipx interface
•show ipx nasi connections
•show ipx nhrp
•show ipx nhrp traffic
•show ipx nlsp database
•show ipx nlsp neighbors
•show ipx nlsp spf-log
•show ipx route
•show ipx servers
•show ipx spx-spoof
•show ipx traffic
•show sse summary
•spf-interval
Additional References
The following sections provide references related to the Disable Novell IPX/NLSP/SAP feature.
Related Documents
Standards
MIBs
RFCs
Technical Assistance
Description
|
Link
|
The Cisco Support and Documentation website provides online resources to download documentation, software, and tools. Use these resources to install and configure the software and to troubleshoot and resolve technical issues with Cisco products and technologies. Access to most tools on the Cisco Support and Documentation website requires a Cisco.com user ID and password.
|
http://www.cisco.com/cisco/web/support/index.html
|
Feature Information for Disable Novell IPX/NLSP/SAP
Table 1 lists the release history for this feature.
Use Cisco Feature Navigator to find information about platform support and software image support. Cisco Feature Navigator enables you to determine which software images support a specific software release, feature set, or platform. To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not required.
Note Table 1 lists only the software release that introduced support for a given feature in a given software release train. Unless noted otherwise, subsequent releases of that software release train also support that feature.
Table 1 Feature Information for Disable Novell IPX/NLSP/SAP
Feature Name
|
Releases
|
Feature Information
|
Disable Novell IPX/NLSP/SAP
|
15.1(3)S, 15.2(2)T, 15.1(1)SY
|
Support for Novell Internetwork Packet Exchange (IPX) routing using NLSP, SAP, EIGRP, and RIP, related features, and commands has been removed from Cisco IOS Release 15.1(3)S, 15.2(2)T, 15.1(1)SY, and later releases.
The following sections provide information about this feature:
•Information About Disable Novell IPX/NLSP/SAP
•Removal of Support for Novell IPX Commands
|
Cisco and the Cisco Logo are trademarks of Cisco Systems, Inc. and/or its affiliates in the U.S. and other countries. A listing of Cisco's trademarks can be found at www.cisco.com/go/trademarks. Third party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a partnership relationship between Cisco and any other company. (1005R)
Any Internet Protocol (IP) addresses and phone numbers used in this document are not intended to be actual addresses and phone numbers. Any examples, command display output, network topology diagrams, and other figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses or phone numbers in illustrative content is unintentional and coincidental.
© 2011 Cisco Systems, Inc. All rights reserved.
Feedback
