Guest

Cisco Aironet 1400 Series

Cisco Aironet 1400 Series Wireless Bridge Rooftop or Wall Mount Assembly Instructions

  • Viewing Options

  • PDF (193.8 KB)
  • Feedback
Cisco Aironet 1400 Series Wireless Bridge Rooftop or Wall Mount Assembly Instructions

Table Of Contents

Cisco Aironet 1400 Series Wireless Bridge Rooftop or Wall Mount Assembly Instructions

Unpacking the Mount

Package Contents

Assembling the Mount

Obtaining Documentation and Submitting a Service Request


Cisco Aironet 1400 Series Wireless Bridge Rooftop or Wall Mount Assembly Instructions


The rooftop or wall mount is used to mount your bridge to a flat horizontal or vertical surface, such as a building wall or roof. You must assemble the mount before you can use it.

Unpacking the Mount

Follow these steps to unpack the mount:


Step 1 Open the shipping container and carefully remove the contents.

Step 2 Return all packing materials to the shipping container and save it.

Step 3 Ensure that all items listed in the "Package Contents" section are included in the shipment. If any item is damaged or missing, notify your authorized Cisco sales representative.


Package Contents

Your mount package contains the following items:

Mast pipe

Mounting plate

Mounting hardware consisting of the following:

One long flanged hex bolt, 2 in. (5.08 cm)

Two carriage bolts, 0.5 in. (1.27 cm)

Four washers

Three flanged hex nuts

Assembling the Mount

Figure 1 shows the correct locations for the three bolts.

Figure 1 Mount Bolt Locations

1

Long flanged hex bolt

3

Carriage bolt

2

Carriage bolt

 

To assemble the mount, follow the instructions below:


Step 1 Place a washer on the long flanged hex bolt.

Step 2 Place the end of the mast pipe with the bolt holes into the mounting plate (see Figure 1).

Step 3 Align the holes in the mast pipe with the holes in the mounting plate.

Step 4 Insert the long flanged hex bolt and washer into the upper holes on the mounting plate and through the mast pipe (see Figure 1).

Step 5 Place a washer and hex nut on the end of the long flanged hex bolt and hand-tighten.

Step 6 Position the mast pipe and mounting plate as shown in Figure 1.

Step 7 Align the lower square hole in the mast pipe with the semi-circular cut-out on the mounting plate.

Step 8 Place the carriage bolt into the square hole on the inside of the mast pipe.

Step 9 Place a washer and hex nut on the end of the carriage bolt and hand-tighten.

Step 10 Repeat Steps 8 and 9 for the other square hole.

You have completed the assembly of your rooftop or wall mount.


Note You must securely attach the mounting plate to the wall or roof and tighten all nuts (12 to 14 ft-lb).


To mount your rooftop or wall mount, please follow the mounting instructions located in the Cisco Aironet 1400 Series Wireless Bridge Mounting Instructions that shipped with your bridge.


Obtaining Documentation and Submitting a Service Request

For information on obtaining documentation, submitting a service request, and gathering additional information, see the monthly What's New in Cisco Product Documentation, which also lists all new and revised Cisco technical documentation, at:

http://www.cisco.com/en/US/docs/general/whatsnew/whatsnew.html

Subscribe to the What's New in Cisco Product Documentation as a Really Simple Syndication (RSS) feed and set content to be delivered directly to your desktop using a reader application. The RSS feeds are a free service and Cisco currently supports RSS Version 2.0.