show Commands
This section lists the show commands that you can use to display information about the controller ports and interfaces.
show port
To display the Cisco wireless LAN controller port settings on an individual or global basis, use the show port command.
show port {port-number | summary | detailed-info | vlan}
Syntax Description
port-number |
Port number of the physical interface. |
summary |
Displays a summary of all ports. |
detailed-info |
Displays detailed port information. |
vlan |
Displays VLAN port table summary. |
Examples
The following example shows how to display information about an individual wireless LAN controller port:
(Cisco Controller) > show port 1
STP Admin Physical Physical Link Link Mcast
Pr Type Stat Mode Mode Status Status Trap Appliance POE
-- ------- ---- ------- ---------- ---------- ------ ------- --------- -------
1 Normal Disa Enable Auto 1000 Full Down Enable Enable N/A
Note |
Some WLAN controllers may not have multicast or Power over Ethernet (PoE) listed because they do not support those features. |
The following example shows how to display a summary of all ports:
(Cisco Controller) > show port summary
STP Admin Physical Physical Link Link Mcast
Pr Type Stat Mode Mode Status Status Trap Appliance POE SFPType
-- ------- ---- ------- ---------- ---------- ------ ------- --------- -------------
1 Normal Forw Enable Auto 1000 Full Up Enable Enable N/A NotPresent
2 Normal Disa Enable Auto 1000 Full Down Enable Enable N/A NotPresent
3 Normal Disa Enable Auto 1000 Full Down Enable Enable N/A NotPresent
4 Normal Disa Enable Auto 1000 Full Down Enable Enable N/A NotPresent
Note |
Some WLAN controllers may have only one port listed because they have only one physical port. |
show serial
To display the serial (console) port configuration, use the show serial command.
show serial
Syntax Description
This command has no arguments or keywords.
Command Default
The default values for Baud rate, Character, Flow Control, Stop Bits, Parity type of the port configuration are 9600, 8, off, 1, none.
Examples
The following example shows how to display EIA-232 parameters and the serial port inactivity timeout:
(Cisco Controller) > show serial
Serial Port Login Timeout (minutes)......... 45
Baud Rate................................... 9600
Character Size.............................. 8
Flow Control:............................... Disable
Stop Bits................................... 1
Parity Type:................................ none