ipv6
|
Use this option to configure IPv6 FlexConnect ACL rules. If you don't use this option, then IPv4 FlexConnect ACL rules will
be configured.
|
action
|
Configures whether to permit
or deny access.
|
rule_name
|
ACL name that contains up to
32 alphanumeric characters.
|
rule_index
|
Rule index between 1 and 32.
|
permit
|
Permits the rule action.
|
deny
|
Denies the rule action.
|
add
|
Adds a new rule.
|
change
|
Changes a rule’s index.
|
index
|
Specifies a rule index.
|
delete
|
Deletes a rule.
|
destination
address
|
Configures a rule’s
destination IP address and netmask.
|
ip_address
|
IP address of the rule.
|
netmask
|
Netmask of the rule.
|
start_port
|
Start port number (between
0 and 65535).
|
end_port
|
End port number (between 0
and 65535).
|
direction
|
Configures a rule’s
direction to in, out, or any.
|
in
|
Configures a rule’s
direction to in.
|
out
|
Configures a rule’s
direction to out.
|
any
|
Configures a rule’s
direction to any.
|
dscp
|
Configures a rule’s DSCP.
|
dscp
|
Number between 0 and 63, or
any .
|
protocol
|
Configures a rule’s DSCP.
|
protocol
|
Number between 0 and 255,
or
any .
|
source
address
|
Configures a rule’s source
IP address and netmask.
|
source port
range
|
Configures a rule’s source
port range.
|
swap
|
Swaps two rules’ indices.
|
index_1
|
The rule first index to
swap.
|
index_2
|
The rule index to swap the
first index with.
|