Upgrading from BAMS Release 3.10 to BAMS Release 3.12
Introduction
This appendix explains how to upgrade a redundant Cisco Billing and Measurements Server (BAMS) system from Release 3.10 to Release 3.12 software.
Note Before beginning this upgrade procedure, read the entire appendix to familiarize yourself with the prerequisites, major steps, and differences between the two releases.
A conversion utility is provided in the Release 3.12 software that converts configuration and data files from Release 3.10 to Release 3.12 format.
Note Ensure that your Release 3.10 software is up to Patch 3 before commencing this procedure.
Upgrade Procedure
Use the following procedure (on both units for redundant systems) to upgrade from BAMS Release 3.10 to BAMS Release 3.12:
Caution
When you upgrade from Release 3.10 to Release 3.12, measurement data is zeroed out. As well, measurement data that was in progress at the time of the upgrade is not retained.
Step 1 Remove the CSCOcaMPS if installed.
Step 2 Run the bams uninstall script from the /opt/install directory to remove the BAMS package. For complete instructions, see "Uninstalling BAMS" section.
Step 3 Run the bams install script by entering the following commands:
Step 4 Follow the prompts.
When the installation is complete, the system displays the following message: Installation of <CiscoBAMS> was successful.
Step 5 After the installation has successfully completed, reboot the system.
Step 6 Login as the BAMS user and run the upgrade script by entering the following command:
This script converts the Release 3.10 data structures so they are compatible with the Release 3.12 software.
Warning This script should only be run once. Re-executing this script will corrupt the data files which were already converted.