Administration Guide for Cisco Business Edition 3000, Release 8.6(4)
System Notifications Settings
Downloads: This chapterpdf (PDF - 326.0KB) The complete bookPDF (PDF - 5.69MB) | Feedback

System Notifications Settings

System Notifications Settings

GUI: Cisco Business Edition 3000 Administrative Interface

Table 1 describes the configuration settings on the System Notifications page where you can configure your email settings (System Settings > System Notifications).

Table 1 Settings on the System Notifications page

Setting

Description

System Notifications Information

Enable Email Notification

When the check box is checked, the email notification feature is enabled.

Outgoing Email Server

Specify the IP Address (or hostname) of the Simple Mail Transfer Protocol (SMTP) server.

Outgoing Email Server Port

Specify the Outgoing Email Server Port.

The default non-secure and secure port values are 25 and 465 respectively.

Use Secure Email

Check this check box if you want the system to send emails over a secured connection.

Sender Email Address

Specify the sender's email address who has a valid account with the SMTP server.

Sender Email Password

Specify the sender's email password who has a valid account with the SMTP server.

Recipient Email Address

Specify the email address of the recipient to whom the email notifications will be delivered.

Note   

You can add only one recipient to the Recipient address list, or a mail alias.

Send Test Email

Click Send Test Email if you want to validate the email notification settings before saving the settings. If you click this button, a test mail is sent to the recipient email address configured in the System Notifications page.

System Identification Information

System Identifier

This parameter provides a unique identifier for Cisco Business Edition 3000 server. You cannot edit this field in the System Notifications page.

Enter a valid parameter that comprises of (A-Z,a-z,0-9,.,-). The maximum length allowed is 63 digits.

Save

The Save option will save the System Notifications configuration. However, it will give an option to test the configuration if not tested/validated earlier.

Cancel

Click Reset to discard your changes and display the saved data.