The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS multicast routing commands that begin with M.
To configure an outgoing interface statically for a multicast MAC address, use the mac address-table multicast command.
mac address-table multicast multicast-mac-address vlan vlan-id interface interface-name
network-admin
network-operator
vdc-admin
vdc-operator
|
|
This example shows how to configure the specified outgoing interface statically for a multicast MAC address:
switch(config)# mac address-table multicast 01:00:5f:00:00:00 vlan 5 interface ethernet 2/5
|
|