The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS quality of service (QoS) commands that begin with I.
To configure the differentiated dervices code point (DSCP) value of the packets in the Encapsulated Remote Switched Port Analyzer (ERSPAN) traffic, use the ip dscp command. To revert to the default value, use the no form of this command.
DSCP value of the packets in the ERSPAN traffic. The range is from 0 to 63. |
ERSPAN session configuration mode
|
|
---|---|
This example shows how to configure the DSCP value of the packets in the ESRSPAN traffic:
|
|
---|---|
Configures the IP time-to-live (TTL) value of the ERSPAN traffic. |
|
Enters the monitor configuration mode for configuring an ERSPAN session for analyzing traffic between ports. |
To configure the IP time-to-live (TTL) value of the Encapsulated Remote Switched Port Analyzer (ERSPAN) traffic, use the ip ttl command. To revert to the default configuration, use the no form of this command.
IP TTL value of the ERSPAN traffic. The range is from 1 to 255. |
ERSPAN session configuration mode
|
|
---|---|
This example shows how to configure the IP TTL value of the ESRSPAN source:
|
|
---|---|
Configures the DSCP value of the packets in the ERSPAN traffic. |
|
Enters the monitor configuration mode for configuring an ERSPAN session for analyzing traffic between ports. |