The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS Virtual Router Redundancy Protocol (VRRP) show commands.
To show information about the Virtual Router Redundancy Protocol (VRRP), use the show vrrp command.
show vrrp [detail | statistics | summary] [interface if-number] [vr id] [backup | init | master]
Display information for all VRRP groups.
Any command mode
|
|
5.0(3)N1(1) |
This command was introduced. |
This example shows how to display information about VRRP:
switch(config)# show vrrp
Interface VR IpVersion Pri Time Pre State VR IP addr
---------------------------------------------------------------
Ethernet1/5 1 IPV4 200 200 s Y Init 192.0.1.10
switch(config)#
This example shows how to display the detailed configuration information about VRRP:
switch(config)# show vrrp detail
Ethernet1/5 - Group 1 (IPV4)
State is Init(Administratively down)
Virtual IP address is 192.0.1.10
Priority 200, Configured 200
Forwarding threshold(for VPC), lower: 1 upper: 200
Advertisement interval 200
Preemption enabled
Virtual MAC address is 0000.5e00.0101
Master router is Unknown
switch(config)#
This example shows how to displayinformation about a specific virtual router:
switch# show vrrp vr 1
Interface VR IpVersion Pri Time Pre State VR IP addr
---------------------------------------------------------------
Ethernet1/5 1 IPV4 200 200 s Y Init 192.0.1.10
switch#
Table 1 describes the significant fields shown in the display.
|
|
---|---|
clear vrrp |
Clears VRRP statistics. |
feature vrrp |
Enables the VRRP feature. |
vrrp |
Creates a virtual router group. |