The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS Enhanced Interior Gateway Routing Protocol (EIGRP) commands that begin with C.
To clear the prefix accounting information for the Enhanced Interior Gateway Routing Protocol (EIGRP) processes, use the clear ip eigrp accounting command.
clear ip eigrp accounting [vrf {vrf-name | all | default | management}]
None
Any command mode
|
|
5.2(1)N1(1) |
This command was introduced. |
This command requires the LAN Base Services license.
This example shows how to clear the EIGRP accounting information:
switch# clear ip eigrp accounting
To remove and reestablish the Enhanced Interior Gateway Routing Protocol (EIGRP) neighbor entries from the appropriate table, use the clear ip eigrp neighbors command.
clear ip eigrp neighbors [* | ip-address | ethernet slot/[QSFP-module/]port | loopback if_number | port-channel number] [soft] [vrf {vrf-name | all | default | management}]
When no autonomous system number, interface, or VRF instance is specified, all EIGRP neighbor entries are cleared from the table.
Any command mode
|
|
6.0(2)N1(2) |
Support for the QSFP+ GEM was added. |
5.2(1)N1(1) |
This command was introduced. |
This command requires the LAN Base Services license.
This example shows how to clear all EIGRP entries for neighbors on Ethernet interface 2/1:
switch# clear ip eigrp vrf * neighbors ethernet 2/1
|
|
---|---|
show ip eigrp interfaces |
Displays information about interfaces configured for EIGRP. |
show ip eigrp neighbors |
Displays the neighbors discovered by EIGRP. |
To clear redistribution information for the Enhanced Interior Gateway Routing Protocol (EIGRP) , use the clear ip eigrp redistribution command.
clear ip eigrp redistribution [vrf {vrf-name | all | default | management}]
None
Any command mode
|
|
5.2(1)N1(1) |
This command was introduced. |
This command requires the LAN Base Services license.
This example shows how to clear redistribution information:
switch# clear ip eigrp redistribution
|
|
---|---|
feature eigrp |
Enables the EIGRP feature. |
To clear the Enhanced Interior Gateway Routing Protocol (EIGRP) traffic statistics, use the clear ip eigrp traffic command.
clear ip eigrp traffic [vrf {vrf-name | all | default | management}]
This command clears information for the default VRF if no VRF is specified.
Any command mode
|
|
5.2(1)N1(1) |
This command was introduced. |
This command requires the LAN Base Services license.
This example shows how to clear the EIGRP traffic statistics:
switch# clear ip eigrp traffic