Cisco Nexus 1000V Interface Configuration Guide, Release 4.0(4)SV1(2)
New and Changed Information
Downloads: This chapterpdf (PDF - 69.0KB) The complete bookPDF (PDF - 2.65MB) | Feedback

New and Changed Information

Table Of Contents

New and Changed Information


New and Changed Information


This chapter lists the content in this document that is either new or has been changed in Release 4.0(4)SV1(2), and where it is located.

Feature
Description
Changed in Release
Where Documented

Configuration limits

Configuration limits for vEthernet interfaces, vEthernet trunks, and port profiles were added.

4.0(4)SV1(2)

Chapter 7 "Interface Configuration Limits"

show interface vethernet command

The show interface vethernet command now displays 5 minute input and output packet/bit rate statistics for the interfaces that you specify. The configuration example showing this command output was updated to reflect this change.

Note The show interface ethernet command output also provides these new statistics.

4.0(4)SV1(2)

Chapter 4 "Configuring Virtual Ethernet Interfaces"

vPC-Host Mode

Support for manual creation of subgroups.

4.0(4)SV1(2)

Chapter 5 "Configuring Port Channels"

Static Pinning

Support for attaching (or pinning) a vEthernet interface to a specific port channel subgroup.

4.0(4)SV1(2)

Chapter 5 "Configuring Port Channels"