Supervisor Module LEDs
LED |
Color |
Status |
||
---|---|---|---|---|
STATUS |
Green |
All diagnostics pass. The module is operational (normal initialization sequence). |
||
Amber |
Indicates one of the following:
|
|||
Flashing red |
Indicates one of the following:
|
|||
Red |
The module has detected a slot ID parity error and will not power on or boot up. |
|||
Off |
The module is not receiving power. |
|||
ID |
Flashing blue |
The operator has activated this LED to identify this module in the chassis. |
||
Off |
This module is not being identified. |
|||
SYSTEM |
Green |
All chassis environmental monitors are reporting okay. |
||
Amber |
Indicates one of the following:
|
|||
Red |
Indicates one of the following:
|
|||
ACTIVE |
Green |
The supervisor module is operational and active. |
||
Amber |
The supervisor module is in standby mode. |
|||
PWR MGMT |
Green |
Sufficient power is available for all installed modules. |
||
Amber |
Sufficient power is not available for all installed modules. |
|||
LINK |
Green |
The module has detected a link. |
||
Off |
The module does not detect a link. |
|||
ACT |
Flashing green |
The module is transmitting or receiving. |
||
Off |
The module is not transmitting or receiving. |
|||
MGMT ETH
|
Green |
The management port is operational. |
||
Amber |
The management port link has been disabled through the software. |
|||
Flashing amber |
The management port link is bad and has been disabled due to a hardware failure. |
|||
Off |
The module has not detected a signal. |
|||
LOG FLASH |
Green |
The log flash CompactFlash or USB disk is being accessed. Do not remove the media until the LED is off. |
||
Off |
The expansion flash CompactFlash or USB disk is not being accessed. You can remove the media while this LED is off. |
|||
Slot 0 |
Green |
The expansion flash CompactFlash or USB disk is being accessed. Do not remove the media until the LED is off. |
||
Off |
The log flash CompactFlash or USB disk is not being accessed. You can remove the media while this LED is off. |
|||
Off |
The log flash CompactFlash or USB disk is not being accessed. You can remove the media while this LED is off. |
|||
USB1 |
Green |
The expansion flash CompactFlash or USB disk is being accessed. Do not remove the media until the LED is off. |
||
Off |
The log flash CompactFlash or USB disk is not being accessed. You can remove the media while this LED is off. |