Cisco Intrusion Prevention System Command Reference for IPS 5.1
Deprecated Commands and Command Platform Dependencies
Downloads: This chapterpdf (PDF - 75.0KB) The complete bookPDF (PDF - 1.25MB) | Feedback

Deprecated Commands and Command Platform Dependencies

Table Of Contents

Deprecated Commands and Command Platform Dependencies

Deprecated Commands

Command/Platform Dependencies


Deprecated Commands and Command Platform Dependencies


This appendix lists commands that have been deprecated and commands that do not apply to certain platforms. It contains the following sections:

Deprecated Commands

Command/Platform Dependencies

Deprecated Commands

Table A-1 lists the commands that were deprecated for IPS 5.1.

Table A-1 Deprecated Commands 

Command
Replaced By

hostname

service host - network-settings - host-name

ip address

service host - network-settings - host-ip

ip default-gateway

service host - network-settings - host-ip

interface command-control

service host

telnet-sensor

service host - network-settings - telnet-option

interface group

service analysis-engine - virtual-sensor

interface sensing

service interface-config - physical-interfaces

interface sensing shutdown

service interface-config - physical-interfaces - state

sensing-interface

service analysis-engine - virtual-sensor - sensing-interface

service virtual-sensor-configuration

service signature-definition

service-alarm-channel-configuration

service event-action-rules

reset-signatures

No replacement. You can reset an individual signature or all signatures by using the default keyword.

show interfaces command-control

show statistics host

show interface group

show statistics virtual-sensor. This command only displays the virtual sensor statistics. You can view the configuration by using more current-config or show configuration.

show interface sensing

show interface fastethernet and show interface gigabitethernet

tune-micro-engines

No replacement. The service signature-definition command directly enters signature editing.

tune-alarm-channel

No replacement. The service event-action-rules command directly enters rule editing.


Command/Platform Dependencies

Table A-2 lists the commands that are not valid on the specified platforms.

Table A-2 Command/Platform Dependencies

Command
Platforms

display-serial

IDSM-2, NM-CIDS, IDS-4215, AIP-SSM-10, AIP-SSM-20, IPS-4240, IPS-4255

clock set

IDSM-2, NM-CIDS, AIP-SSM-10, AIP-SSM-20

show inventory

IDSM-2, NM-CIDS, IDS-4210, IDS-4235, IDS-4250, AIP-SSM-10, AIP-SSM-20

show interfaces management

IDSM-2, NM-CIDS, IDS-4210,IDS-4215, IDS-4235, IDS-4250, AIP-SSM-10, AIP-SSM-20