Power Button Shut Down
The AMP PC3000 runs in two modes:
-
Main power mode—Power is supplied to all AMP PC3000 components and all operating systems can run.
-
Standby power mode—Power is supplied only to the service processor and certain components. You can safely remove power cords from the AMP PC3000 in this mode.
Caution |
After you shut down the AMP PC3000 to standby power, electric current is still present in the chassis. To completely remove power as directed in some maintenance procedures, you must disconnect all power cords from all power supplies on the AMP PC3000. |
You can shut down the AMP PC3000 using the front panel Power button or software management. See NEED XREF for the software procedures.
Procedure
Step 1 |
Check the Power LED:
|
||
Step 2 |
Perform a graceful shutdown or a hard shutdown:
|
||
Step 3 |
If a maintenance procedure instructs you to completely remove power from the AMP PC3000, disconnect all power cords from the power supplies. |