Guest

Cisco ONS 15454 Series Multiservice Provisioning Platforms

Installing IEC Rack Mounting Brackets on the ONS 15454 SDH Shelf Assembly

  • Viewing Options

  • PDF (222.2 KB)
  • Feedback
Installing IEC Rack Mounting Brackets on the ONS 15454 SDH Shelf Assembly

Table Of Contents

Installing IEC Rack Mounting Brackets on the ONS 15454 SDH Shelf Assembly

IEC Rack Kit

Install the Mounting Brackets

Related Documentation

Obtaining Documentation and Submitting a Service Request


Installing IEC Rack Mounting Brackets on the ONS 15454 SDH Shelf Assembly


Product Name: 15454E-19IEC-KIT=

This document provides installation procedures for installing mounting brackets on the ONS 15454 SDH shelf, to allow the shelf assembly to be installed in a 19- inch IEC rack (IEC-297-1). Use this document in conjunction with the Cisco ONS 15454 SDH Procedure Guide.

This document contains the following sections:

"IEC Rack Kit" section

"Install the Mounting Brackets" section

"Related Documentation" section

"Obtaining Documentation and Submitting a Service Request" section

This document contains the following procedures:

"Install the Mounting Brackets" procedure

IEC Rack Kit

The IEC rack mounting kit for the ONS 15454 SDH shelf includes the following items.

IEC-297 Compatible 19 in. brackets (2)

Pan Head M4.0 x 8mm mounting screws (12)

Install the Mounting Brackets

To perform this procedure you will need the IEC rack mounting kit and a Phillips screwdriver.


Step 1 Verify that your shelf assembly is equipped with the low profile IEC rack compatible fiber guides.

Step 2 If necessary, replace the fiber guides with new guides from kit 15454E-19FGD-KIT=.

Step 3 Align the mounting bracket screw holes against the shelf assembly screw holes according to Figure 1, depending on whether you want to mount the shelf at the front or the center of the equipment rack. When aligned properly the mounting flange will be 38 mm from the front edge of the shelf assembly when front mounted (Figure 2) and 114.5 mm when center mounted (Figure 3).

Step 4 Use a Phillips screwdriver to install the six screws and tighten.

Step 5 Repeat for the other side of the assembly.


Figure 1 Bracket Mounting Holes

Figure 2 Positioning the Mounting Brackets for Front Mounting

Figure 3 Positioning the Mounting Brackets for Center Mounting

Refer to the Cisco ONS 15454 SDH Procedure Guide for procedures to install the shelf assembly in a rack.

Related Documentation

Cisco ONS 15454 SDH Procedure Guide

Cisco ONS 15454 SDH Troubleshooting Guide

Cisco ONS 15454 SDH Reference Manual

Obtaining Documentation and Submitting a Service Request

For information on obtaining documentation, submitting a service request, and gathering additional information, see the monthly What's New in Cisco Product Documentation, which also lists all new and revised Cisco technical documentation, at:

http://www.cisco.com/en/US/docs/general/whatsnew/whatsnew.html

Subscribe to the What's New in Cisco Product Documentation as an RSS feed and set content to be delivered directly to your desktop using a reader application. The RSS feeds are a free service. Cisco currently supports RSS Version 2.0.