|
|
October 2008 |
Added a reference to “CTC Port Numbers and TL1 Aids” section of TL1 Command Guide, in the Power Monitoring sections. |
November 2008 |
Updated the section “Compatibility by Card” in the chapter, “Transponder and Muxponder Cards”. |
December 2008 |
- Added new section on DCN Extension in Chapter 16, Management Network Connectivity.
- Added a note in the “Y-Cable and Splitter Protection” section of Chapter 9, Transponder and Muxponder Cards.
|
February 2009 |
- Updated the section “System Environmental Specifications” in Appendix-A, “Hardware Specifications”.
- Added a note in the section “Y-Cable Protection” of chapter “Transponder and Muxponder Cards”.
|
March 2009 |
- Added a note in the “SFP Specifications” section of Appendix A, “Hardware specifications”.
- Added the optical module functional block diagram for the OPT-AMP-C card in the chapter, Optical Amplifier Cards.
- Added a note to the section "GE_XP, 10GE_XP, GE_XPE, and 10GE_XPE Cards" in the chapter, “Transponder and Muxponder Cards”
- Updated details of ONS-SE-ZE-EL SFP in Chapter 9, Transponder and Muxponder Cards and Appendix A, Hardware specifications.
|
April 2009 |
Added a note in the section “Automatic Power Reduction” of chapter 11, “Network Reference”. |
June 2009 |
Updated the section, Supported Node Configurations for OPT-RAMP-C Card in the chapter, Node Reference. |
July 2009 |
- Updated the minimum output power (with one channel) value in the “A.5 Optical Amplifier Cards” section of Appendix A, Hardware specifications.
- Updated the table “XFP Specifications” and added the table “Multimode Fiber XFP Port Cabling Specifications” in “XFP Specifications” section of Appendix A, Hardware specifications.
|
August 2009 |
Added details on how the throughput of the MXP_MR_10DME_C and MXP_MR_10DME_L cards is affected in Chapter 8, Transponder and Muxponder Cards. |
September 2009 |
- Added a new section titled “Management of Non-LAN Connected Multishelf Node” in Chapter 16, Management Network Connectivity.
- Added a note to the section, “Span Loss Verification” in the chapter, Network Reference.
|
October 2009 |
- Added values for power requirements for OPT-RAMP-C card in Appendix A, Hardware Specifications.
- Updated the section, IGMP Snooping in the chapter, Transponder and Muxponder cards.
|
November 2009 |
- Updated the section “32WSS Block Diagram” in the chapter “Reconfigurable Optical Add/Drop Cards”.
- Added a note in “GE_XP, 10GE_XP, GE_XPE, and 10GE_XPE Cards” section of chapter, Transponder and Muxponder Cards.
- Updated the table "2R and 3R Mode and ITU-T G.709 Compliance by Client Interface" in chapter, Transponder and Muxponder Cards.
- Updated the table “Card View Tabs and Subtabs” in Chapter, Cisco Transport Controller Operation.
- Updated the section “Layer 2 Over DWDM Protection” in the chapter “Transponder and Muxponder Cards”.
|
February 2010 |
- Changed the BIEC parameter to BIT-EC in Chapter, “Performance Monitoring”.
- Updated the SFP/XFP Card Compatibility table for ADM-10G card in chapter Transponder and Muxponder Cards.
|
March 2010 |
- Updated the section “Client Interface” under the section “GE_XP, 10GE_XP, GE_XPE, and 10GE_XPE Cards” in the chapter “Transponder and Muxponder Cards”.
- Added the section, “Mesh Patch Panel Specifications” in the appendix, Hardware Specifications.
- Updated the table “Multimode Fiber SFP Port Cabling Specifications” in the appendix “Hardware Specifications”.
|
April 2010 |
- Updated the section “SNMP Overview” in the chapter “SNMP”.
- Created a section “Fan Tray Units for ONS 15454 Cards” in the chapter “Shelf Assembly Hardware”.
- Added footnote and note for ONS-SC-2G-28.7 SFP in the chapter “Transponder and Muxponder Cards” and appendix “Hardware Specifications”.
|
June 2010 |
- Updated the table “ONS 15454 Security Levels—Node View” in the chapter “Security Reference”.
|
July 2010 |
- Updated the table “SFP/XFP Card Compatibility” in the chapter “Transponder and Muxponder Cards”.
- Updated the section “GE_XP, 10GE_XP, GE_XPE, and 10GE_XPE Card Specifications” in the appendix, “Hardware Specifications.”
- Updated the following sections:
– Updated the key features for the MXP_MR_10DME card in the chapter, Transponder and Muxponder Cards. – Updated the section, Y-cable protection in the chapter, Transponder and Muxponder Cards. |
August 2010 |
- Updated the table “Node View (Single-Shelf Mode) or Shelf View (Multishelf Mode) Tabs and Subtab” in the chapter, “Cisco Transport Controller Operation”.
|
September 2010 |
- Added the FAPS switching criteria in the section, “Layer 2 Over DWDM Protection” in the chapter, “Transponder and Muxponder Cards”.
|
October 2010 |
Updated the "Class 1M Laser Product Statement" section in the chapters “Optical Amplifier Cards”, “Multiplexer and Demultiplexer Cards”, “Optical Add/Drop Cards”, “Reconfigurable Optical Add/Drop Cards”, and “Transponder and Muxponder Cards”. |
November 2010 |
- Updated the section, “SNMP in Multishelf Management” in the chapter, SNMP.
- Updated the width of the single slot cards for Control cards and Transponder and Muxponder Cards in the appendix, "Hardware Specifications".
- Updated the table “SFP/XFP Card Compatibility” in the chapter “Transponder and Muxponder Cards”.
- Updated the tables “SFP Specifications” and “Single-Mode Fiber SFP Port Cabling Specifications” in the appendix, “Hardware Specifications”.
|
January 2011 |
- Updated the width of all the cards in the appendix, "Hardware Specifications".
|
April 2011 |
- Updated the section “Interllink Interfaces” and the table “SFP/XFP Card Compatibility” in the chapter “Transponder and Muxponder Cards”.
- Updated the section “Safety Labels” in the following chapters:
– Optical Service Channel Cards – Optical Amplifier Cards – Multiplexer and Demultiplexer Cards – Optical Add/Drop Cards – Reconfigurable Optical Add/Drop Cards – Transponder and Muxponder Cards
- Updated the power values in the “Individual Card Power Requirements” table in the appendix, “Hardware Specifications”.
|
May 2011 |
- Updated the section “SFP and XFP Modules” in the chapter “Transponder and Muxponder Cards”.
- Removed the sections “SFP Specifications” and “XFP Specifications” and added the section “SFP and XFP Specifications” in the appendix “Hardware Specifications”.
|
June 2011 |
- Updated the section “AIC-I Card” in the chapter “Common Control Cards”.
- Updated the section “Y-Cable Protection” in the chapter “Transponder and Muxponder Cards”.
|
July 2011 |
- Added a note in the “PC and UNIX Workstation Requirements” section of Chapter, “Cisco Transport Controller Operation”.
|
August 2011 |
- Updated the sub-section “Configuration Management” under the section “OTU2_XP Card” in the chapter “Transponder and Muxponder Cards”.
|
September 2011 |
- Updated the key features section of TXP_MR_10G, TXP_MR_10E, TXP_MR_10E_C, TXP_MR_10E_L, and OTU2_XP cards in the chapter “Transponder and Muxponder Cards”.
- Added a note to SONET PM Parameters table in “SONET PM Parameter Definitions” section.
- Replaced G.975.1 with G.975.1 I.7 and added a note in the chapter, "Transponder and Muxponder Cards".
- Created a “Summary Pane” section in the chapter, “Cisco Transport Controller Operation”.
|
October 2011 |
- Removed the Temperature table and updated the Temperature section with standard operating temperature values and removed the Environmental section from all the 15454 card specifications in the appendix "Hardware Specifications."
- Updated the figure “Scenario 3: Using Proxy ARP with Static Routing (ANSI and ETSI)” in the chapter “Management Network Connectivity”.
|
December 2011 |
- Updated the power values in the table “Individual Card Power Requirements” in the appendix “Hardware Specifications”.
- Updated the section “Termination Modes” in the chapter “Transponder and Muxponder Cards”.
|
February 2012 |
Removed the autonegotiation support statement for ADM-10G card from the “Key Features” section in the chapter “Transponder and Muxponder Cards”. |
April 2012 |
- Updated the "Faceplate and Block Diagram" section of "GE_XP, 10GE_XP, GE_XPE, and 10GE_XPE Cards" in the chapter, “Transponder and Muxponder Cards”.
- Upadted the section “SNMP in Multishelf Management” in the chapter “SNMP”.
|
May 2012 |
Updated the section “Optical Channel Circuits” in the chapter “Optical Channel Circuits and Virtual Patchcords Reference”. |
June 2012 |
Updated the section “Generic Threshold and Performance Monitoring MIBs” in the chapter “SNMP”. |
July 2012 |
Document Part Number revisioned to 78-18377-02 and a full length book-PDF was generated. |
August 2012 |
Updated the power values in the table “Individual Card Power Requirements” in the appendix “Hardware Specifications”. |
October 2012 |
- Updated the “Circuit Provisioning” section of ADM-10G card in the chapter “Transponder and Muxponder Cards”.
- Added a caution to the section, “IP Addressing with Secure Mode Enabled” in the chapter, “Management Network Connectivity”.
|
December 2012 |
Renamed chapter "Management Network Connectivity" to "Manage Network Connectivity". |
April 2013 |
Updated the section “External Firewalls” in the chapter “Manage Network Connectivity”. |
June 2013 |
Updated the section “Administrative States” in the chapter “Administrative and Service States”. |
November 2013 |
Updated the section “Trunk Interface” of OTU2_XP card in the chapter “Transponder and Muxponder Cards”. |