Cisco ONS 15454 SDH TL1 Command Guide, Release 7.0
Chapter 20, RST Commands
Downloads: This chapterpdf (PDF - 154.0KB) The complete bookPDF (PDF - 11.48MB) | Feedback

RST Commands

Table Of Contents

RST Commands

20.1  RST-<MOD2>

20.2  RST-EQPT


RST Commands


This chapter provides RST (restore) commands for the Cisco ONS 15454 SDH.

20.1  RST-<MOD2>

Restore (10GFC, 10GIGE, 1GFC, 1GFICON, 2GFC, 2GFICON, CLNT, D1VIDEO, DS3I, DV6000, E1, E3, E4, ESCON, ETRCLO, FSTE, G1000, GFPOS, GIGE, HDTV, ISC1, STM4, STM64, STM1, STM16, OCH, OMS, OTS, POS, STM1E, VC3, VC44C, VC38C, VC464C, VC48C, STS36C, VC4, VC416C, VC42C, VC43C, VC11, VC12)

Usage Guidelines

This command provisions a facility in service.

See Table 27-1 for supported modifiers by platform.

Category

Ports

Security

Maintenance

Input Format

RST-<MOD2>:[<TID>]:<AID>:<CTAG>::::[<PST>[,<SST>]];

Input Example

RST-E1:CISCO:FAC-1-1:1::::UNLOCKED,AUTOMATICINSERVICE;

Input Parameters

Table 20-1 RST-<MOD2> Input Parameters 

Parameter and Values
Description

AID

Access identifier from the "ALL" section

PST

Primary state

Parameter type is PST—indicates the current overall service condition of an entity

Unlocked

In service

Locked

Out of service

SST

Secondary state

Parameter type is SST—provides additional information pertaining to PST and PSTQ

AutomaticInService

Automatic in service

Disabled

Disabled

Loopback

Loopback

MismatchofEquipmentAlarm

Mismatch of equipment and attributes

Maintenance

Maintenance mode

OutOfGroup

Out of group

SoftwareDownload

Software downloading

Unassigned

Unassigned

NotInstalled

Unequipped


20.2  RST-EQPT

Restore Equipment

Usage Guidelines

This command provisions equipment into the In Service state from the Maintenance state.


Note Only applicable to equipment that is in transition from the Maintenance state to the In-Service state.


Category

Equipment

Security

Maintenance

Input Format

RST-EQPT:[<TID>]:<AID>:<CTAG>[::];

Input Example

RST-EQPT:CISCO:SLOT-1:1;

Input Parameters

Table 20-2 RST-EQPT Input Parameters 

Parameter and Values
Description

AID

Access identifier from the "EQPT" section