Table Of Contents
EOT Support for Carrier Delay
EOT Support for Carrier Delay
The EOT Support for Carrier Delay feature enables Enhanced Object Tracking (EOT) to consider the carrier-delay timer when tracking the status of an interface.
If a link fails, by default there is a two-second timer that must expire before an interface and the associated routes are declared as being down. If a link goes down and comes back up before the carrier delay timer expires, the down state is effectively filtered, and the rest of the software on the switch is not aware that a link-down event occurred. You can configure the carrier-delay seconds command in interface configuration mode to extend the timer up to 60 seconds.
When Enhanced Object Tracking (EOT) is configured on an interface, the tracking may detect the interface is down before a configured carrier-delay timer has expired. This is because EOT looks at the interface state and does not consider the carrier delay timer. Use the carrier-delay command in tracking configuration mode to enable tracking to consider the carrier-delay timer configured on an interface.
Configuration information is included in the "Configuring Enhanced Object Tracking" chapter of the IP Application Services Configuration Guide, Cisco IOS Release 12.4T, at the following URL:
The following sections provide information about this feature:
•EOT Support for Carrier Delay
•Tracking the Line-Protocol State of an Interface
•Tracking the IP-Routing State of an Interface
•Interface IP Routing: Example
For a complete list of features included in the "Configuring Enhanced Object Tracking" module, refer to the Feature Information Table located toward the end of the module.
Command Reference Information
Command reference information is included in the IP Application Services Command Reference at the following URL:
New or Modified Commands
The following commands are new or modified for this feature:
List of All Release 12.4T Commands
An alphabetical list of all Cisco IOS Release 12.4T commands is in the Cisco IOS Master Command List, Release 12.4T, at the following URL:
List of All New, Modified, Removed, and Replaced Release 12.4T Commands
Alphabetized lists of all new, modified, removed, and replaced commands for each Cisco IOS Release 12.4T release are in the Cisco IOS New, Modified, Removed, and Replaced Commands, Release 12.4T, document at the following URL:
Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of Cisco trademarks, go to this URL: www.cisco.com/go/trademarks. Third-party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a partnership relationship between Cisco and any other company. (1110R)
Any Internet Protocol (IP) addresses used in this document are not intended to be actual addresses. Any examples, command display output, and figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses in illustrative content is unintentional and coincidental.
© 2006 Cisco Systems, Inc. All rights reserved.