Cisco IOS IP Routing: LISP Command Reference
LISP Global Configuration Commands
Downloads: This chapterpdf (PDF - 1.18MB) The complete bookPDF (PDF - 4.0MB) | The complete bookePub (ePub - 462.0KB) | Feedback

LISP Global Configuration Commands

LISP Global Configuration Commands

router lisp

To enter Locator/ID Separation Protocol (LISP) configuration mode and configure LISP commands on a router, use the router lisp command in global configuration mode. To remove LISP configuration, use the no form of this command.

router lisp

no router lisp

Syntax Description

This command has no arguments or keywords.

Command Default

By default, the router is not enabled to run LISP.

Command Modes

Global configuration (config)

Command History

Release

Modification

Cisco IOS XE Release 3.3.0S

This command was introduced.

15.1(4)M

This command was integrated into Cisco IOS Release 15.1(4)M.

Usage Guidelines

The router lisp command is applicable to all LISP devices. Use the router lisp command to enter LISP configuration mode. In LISP configuration mode, you can configure most attributes associated with a LISP site. (LISP interface configuration commands are entered in interface configuration mode). Use the no form of the command to remove all LISP configurations from the router.

Examples

The following example shows how to enter LISP site configuration mode.

Router(config)# router lisp
Router(config-router-lisp)#