The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
A
activation
verifying for carrier card 3-6
verifying for modules 4-7
B
blank filler plate
for empty chassis slots 3-7
for empty subslots 4-7
for empty subslots in a carrier card 1-1
part number of 4-7
C
CLI 1-8
command line interface. See CLI
CompactFlash 1-3
configure terminal command 3-5
D
deactivation
verifying for carrier card 3-6
verifying for modules 4-7
debug commands 5-3
E
environmental
requirements 1-5
H
hw-module subslot shutdown command 3-6, 4-6
I
installation
tools and parts required 2-2
L
LEDs 1-7
M
memory
requirements 1-3
module
deactivating 4-5
reactivating 4-6
N
no hw-module subslot shutdown command 4-6
no power enable module command 3-5
O
OIR
online insertion and removal. See OIR
P
packing
an SSC-600 for shipment 5-4
a VSPA for shipment 5-4
physical specifications
SSC-600 1-6
VSPA 1-7
power
requirements 1-4
power enable module command 3-6
S
shipping
an SSC-600 5-4
a VSPA 5-4
show ip interface command 4-7
show module command 3-6
show module slot command 3-6, 4-4
show power command 1-4
Software Advisor tool 1-3
SSC-600 Carrier Card
reactivating 3-5
subslots
description 1-1
supervisor engine
requirements 1-3
T
troubleshooting the installation 5-1
U
using show commands
to verify module status 4-4
V
verifying the installation 4-3
VSPA 1-7