Cisco Wide Area Application Engine 7341, 7371, and 674 Hardware Installation Guide
Wide Area Application Engine Hardware Specifications
Downloads: This chapterpdf (PDF - 82.0KB) The complete bookPDF (PDF - 5.74MB) | Feedback

Wide Area Application Engine Hardware Specifications

Table Of Contents

Wide Area Application Engine Hardware Specifications

Appliance Specifications

Adapter Specifications


Wide Area Application Engine Hardware Specifications


This appendix provides hardware specifications for the WAE-7371, WAE-7341, and WAE-674 appliances and the optional Cisco WAE inline network adapter. It contains the following sections:

Appliance Specifications

Adapter Specifications

Appliance Specifications

Table A-1 provides a summary of the features and specifications of the Wide Area Application Engine (WAE) 7371, 7341, and 674.

Table A-1 WAE 7371, 7341, and 674 Features and Specifications 

Specification
Description

Microprocessor

WAE-7371: 2 Xeon quad-core processors, 2.33 GHz

WAE-7341: 1 Xeon quad-core processor, 2.33 GHz

WAE-674: 1 Xeon quad-core processor, 2.00 GHz

8 MB Level 2 cache

1333-MHz front-side bus (FSB)


Note Use the Configuration/Setup utility program to determine the type and speed of the microprocessors.


Memory

WAE-7371: 24 GB

WAE-7341: 12 GB

WAE-674: 4 GB (optionally 8 GB)

Drives standard

DVD-ROM/CD-RW combination drive

WAE-7371: RAID-5 array with six 300-GB SAS hard disk drives

WAE-7341: RAID-5 array with four 300-GB SAS hard disk drives

WAE-674: RAID-5 array with three 300-GB SAS hard disk drives

Expansion bays

6 hot-swap, 3.5-inch hard disk drive bays

1 5.25-inch (13.34-cm) bay (DVD-ROM/CD-RW combination drive installed)

Fans

WAE-7371 and WAE-7341: 10 fans

WAE-674: 5 fans (optionally 10 fans)

Hot-swap Power supplies

WAE-7371 and WAE-7341: 2 hot-swap, 835 W, 100-240 VAC

WAE-674: 1 hot-swap, 835 W, 100-240 VAC (optionally 2 power supplies)

Expansion slots

2 PCI-X non-hot-pluggable 133-MHz/64-bit (one full length and one half length)

2 PCI-Express non-hot-pluggable (low profile)

Size

Height: 3.36 in. (85.4 mm)

Depth: 27.8 in. (705.0 mm)

Width: 17.5 in. (443.6 mm)

Weight

46.5 lb (21.09 kg) to 64 lb (29.03 kg) depending upon configuration

Integrated functions

Baseboard management controller

2 Broadcom 10/100/1000 Ethernet controllers (dual-port design) with Wake on LAN support

1 serial port

1 RAID controller

1 serial attached SCSI (SAS) controller


Note The baseboard management controller is also known as the service processor.


Electrical Input

Sine wave input (50-60 Hz) required

Input voltage range automatically selected

Input voltage low range:

Minimum: 100 VAC

Maximum: 127 VAC

Input voltage high range:

Minimum: 200 VAC

Maximum: 240 VAC

Input kilovolt-amperes (kVA) approximately:

Minimum: 0.29 kVA

Maximum: 1.0 kVA

Environment

Air temperature:

Device on: 50 to 95×F (10 to 35×C); altitude: 0 to 914.4 m (3000 ft)

Device off: 50 to 109.4×F (10 to 43×C); maximum altitude: 2133 m (7000 ft)

Humidity

Device on: 8 to 80%

Device off: 8 to 80%

1 Acoustical noise emissions

Declared sound power, idle: 6.8 bel2

Declared sound power, operating: 6.8 bel

3 Heat Output

Minimum configuration: 1230 Btu4 (360 watts)

Maximum configuration: 3390 Btu (835 watts)

1 These levels were measured in controlled acoustical environments according to the procedures specified by the American National Standards Institute (ANSI) S12.10 and ISO 7779 and are reported in accordance with ISO 9296. Actual sound-pressure levels in a given location might exceed the average values stated because of room reflections and other nearby noise sources. The declared sound-power levels indicate an upper limit, below which a large number of computers will operate.

2 In acoustics, the logarithm of the ratio of a quantity to a reference quantity of the same kind is called a level. The base of the logarithm (always ten, unless otherwise specified), the reference quantity, and the kind of level shall be specified. bel is a unit of level when the base of the logarithm is ten, and the quantities concerned are proportional to power.

3 Power consumption and heat output vary depending on the number and type of optional features installed and the power-management optional features in use.

4 BTU = British Thermal Unit.


Adapter Specifications

Table A-2 describes the inline network adapter technical and general specifications.

Table A-2 Inline Network Adapter Specifications 

Specification
Description
Copper Gigabit Ethernet Specifications

IEEE standard

Gigabit Ethernet, 1000BASE-T

Fast Ethernet, 100BASE-T

Ethernet, 10BASE-T

Full duplex and half duplex

Supports both half-duplex and full-duplex operation in all operating speeds

Autonegotiation

Autonegotiates between full-duplex and half-duplex operations and between 1000-Mbps, 100-Mbps, and 10-Mbps speeds

Data transfer rate

1000-Mbps, 100-Mbps, and 10-Mbps speeds per port in half-duplex mode

2000-Mbps, 200-Mbps, and 20-Mbps speeds per port in full-duplex mode

General Technical Specifications

Interface standard

PCI v2.2 32/64 bit, 33/66 MHz

PCI-X v1.0 32/64 bit, 66/100/133 MHz

Size

6.6 x 4.2 in. (167.64 x 106.68 mm)

PCI connector

Universal 64-bit connector

PCI voltage

+12 V (minimum 11.4 V, maximum 12.6 V)

+3.3 V (minimum 3.0 V, maximum 3.6 V)

Weight

6.18 oz (175 g)

Operating humidity

0 to 90%, noncondensing

Operating temperature

32 to -122oF (0 to 50oC)

Storage temperature

-4 to -149oF (-20 to -65oC)