The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
First Published: May 26, 2015
Revised: June 12, 2015
Read this module before you perform an initial installation or upgrade of the Cisco StadiumVision Mobile software. It includes the following topics:
Be sure that you understand and have met the following prerequisites before you begin to install or upgrade Cisco StadiumVision Mobile hardware:
http://www.cisco.com/c/en/us/td/docs/Sports_Entertainment/StadiumVision/Mobile/release/notes/2_1/SV_Mobile_Relnotes_2_1.html
When using a Cisco UCS C220 server, observe the following guidelines before starting the installation:
Note If you are doing a fresh installation on a previously configured system, a full install will erase the Cisco StadiumVision Mobile Streamer or Cisco StadiumVision Mobile Reporter configuration. Perform a backup prior to installing to preserve configuration data. See the Cisco StadiumVision Mobile Streamer Administration Guide or Cisco StadiumVision Mobile Reporter Administration Guide for instructions on performing a backup available at:
http://www.cisco.com/c/en/us/support/video/stadiumvision/products-maintenance-guides-list.html
Before starting an installation or upgrade, make sure the prerequisite hardware and cabling have been installed and set up:
See the Cisco UCS C220 Server Installation and Service Guide for additional installation information available at:
http://www.cisco.com/en/US/docs/unified_computing/ucs/c/hw/C220/install/C220.pdf
The Cisco StadiumVision Mobile Reporter and Cisco StadiumVision Mobile Streamer are supported on the following platforms:
VMware vSphere ESX Tested Versions for Cisco StadiumVision Mobile
Cisco StadiumVision Mobile 2.1 has been tested with vSphere Client version 5.1.0, build 786111 and VMWare vCenter Server version 5.1.0, build 947673. Cisco StadiumVision Mobile is supported on all versions of vSphere 5.1 and 5.5.
Note Any VMware license that does not allow your virtual machine to be set to the minimum requirements described in Table 1 and Table 2 is not supported.
Restrictions for Virtual Server Support
Be sure that you consider the following restrictions before you configure a virtual server environment for Cisco StadiumVision Mobile:
This section describes the prerequisite actions before performing an installation, and contains the following sections:
Note If you are running Cisco StadiumVision Mobile Streamer or Reporter as a leaf node in a NTP network (as most are) then you should remove the undisciplined local clock to avoid having two clock sources. For additional information, refer to “Removing the Undisciplined Local Clock” section. Remove the undisciplined local clock on any new installation or upgrade that sets an NTP server.
The upgrade process for an existing server running Cisco StadiumVision Mobile Release 2.0 involves the following tasks:
Note Cisco StadiumVision Mobile Reporter build 2.0.1-1 is the only supported build for Cisco StadiumVision Mobile Release 2.1. If you are using Reporter build 2.0.0-365, you must upgrade to 2.0.1-1.
For detailed information, see the “Using the Software Manager to Upgrade Cisco StadiumVision Mobile Software for Reporter and Streamer” module.
The installation process for a new Cisco StadiumVision Mobile server running Cisco StadiumVision Mobile Release 2.1 involves the following tasks:
http://www.cisco.com/c/en/us/support/video/stadiumvision/products-release-notes-list.html
Table 3 lists the platform, type of media, and file to use to perform a fresh installation.
|
|
|
|
---|---|---|---|
|
|||
The installation process for a virtual server running Cisco StadiumVision Mobile software release 2.1 for the first time involves the following tasks: