This document describes one reason why the Cisco Customer Response Solutions (CRS) server (3.x and earlier) fails to backup and provides a solution in a Cisco IP Contact Center (IPCC) Express environment.
Note: For troubleshooting backup issues related to the Cisco Unified Contact Center Express 7.x, refer to Unified Contact Center Express Back up Issue.
Cisco recommends that you have knowledge of these topics:
The information in this document is based on these software and hardware versions:
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
Refer to Cisco Technical Tips Conventions for more information on document conventions.
Although any server in the Cisco CallManager cluster can be the backup server, it is recommended that the Publisher database server be the backup server. One backup server is required within a Cisco CallManager cluster.
A data source server (or backup target) contains the data to be backed up for Cisco CallManager or Cisco Customer Response Solutions (CRS). A Cisco CallManager cluster can contain zero, one or more data source servers. You designate a server as a data source server (backup target). The backup log file, stiBackup.log, is located in the following folder: C:\Program Files\Common Files\Cisco\Logs.
Figure 1 demonstrates the topology. The backup server is the CallManager and the backup target is a CRS server.
Figure 1—A Simple Setup - Backup Server (CallManager) and Backup Target (CRS)
While you back up the CRS server, the STI Backup Service fails with Login failed for user or Fatal Error - Error finding SQL database , as Figure 2 shows.
Figure 2—Fatal Error - Error Finding SQL Database
In order to support the backup, the STI Backup Service must be installed on both the backup server and target. The installation automatically creates the BackAdmin account. This account supports the backup service on a Cisco CallManager. You must use the same password for this account on both the backup server and target. Without this account and password on both the backup server and target , the backup fails.
When this problem occurs, the CRS server (backup) does not have the STI Backup Service installed. In order to resolve this issue, install the STI Backup Service on the backup target (CRS) and assign the same password for the BackAdmin account as the password used for the BackAdmin account on the CallManager.
Manual backup fails at 98% with Archive_CREATION_ERROR error message.
This error occurs because the CRS server was unable to access the backup location and write the .tar file into the backup folder. Change the storage location to the local server in order to resolve this issue.