Guest

Cisco Unified Contact Center Express

Failure to Log in to Cisco IPCC Express after Rebuilding Cisco IPCC Express Server

Cisco - Failure to Log in to Cisco IPCC Express after Rebuilding Cisco IPCC Express Server

Document ID: 45740

Updated: Oct 25, 2005

   Print

Introduction

This document describes one reason why the Cisco IP Contact Center (IPCC) agent fails to log in to Cisco IPCC Express after the Cisco IPCC Express server is rebuilt.

Before You Begin

Conventions

For more information on document conventions, see the Cisco Technical Tips Conventions.

Prerequisites

Readers of this document should be knowledgeable of the following:

  • Cisco CallManager

  • Cisco IPCC Express

Components Used

The information in this document is based on the software and hardware versions below.

  • Cisco CallManager 3.2.x

  • Cisco IPCC Express 3.x

The information presented in this document was created from devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If you are working in a live network, ensure that you understand the potential impact of any command before using it.

Symptom

After the Cisco IPCC Express server is rebuilt, agents with Administrator attributes fail to authenticate. When an attempt to log into IPCC Express server is made, the agent receives this error message.

Figure 1: Failure to Authenticate

IPCCExp-LogInFail-1.gif

Resolution

When the Cisco IPCC Express server is rebuilt, agents with Administrator attributes are lost. You must assign the agent Administrator attributes. The procedure follows:

  1. Rename ccndir.ini which is located in C:\WINNT\system32\ccn to ccndir.ini.old.

    Note: C: represents the drive where Cisco IPCC Express is installed on.

  2. Select Start > Programs > Cisco CRA Administrator > Application Administrator. Figure 2 appears.

    Figure 2: Customer Response Applications Administration -- Authentication

    IPCCExp-LogInFail-2.gif

  3. Enter default User Identification, Administrator and the default Password, ciscocisco. Figure 3 appears.

    Figure 3: Customer Response Applications Administration

    IPCCExp-LogInFail-3.gif

  4. Click Tools.

  5. Select User Maintenance in the drop-down box. Figure 4 appears.

    Figure 4: Customer Response Applications Administration -- User Maintenance

    IPCCExp-LogInFail-4.gif

  6. In the CMUsers list box, select an available Cisco CallManager user.

  7. Click the right arrow to move that user to the CRA Administrator/Supervisor list box. A label that identifies the user as an administrator now follows the user name, as shown in Figure 5.

    Figure 5: Customer Response Applications Administration -- User Maintenance

    IPCCExp-LogInFail-5.gif

  8. Click Update to complete the user maintenance process and initialize configuration and repository profiles.

After the above procedure is complete, agents with Administrator attributes are able to log in to Cisco IPCC Express server successfully.

Related Information

Updated: Oct 25, 2005
Document ID: 45740