Guest

Cisco Small Business Voice Systems

Setting-Up SPA3000 as a PSTN Gateway of SPA9000

Document ID: 108762

Updated: Dec 12, 2008

   Print

Contents

Introduction
How can I set-up the SPA3000 as PSTN Gateway of SPA9000 to make all calls go to Auto Attendant and allow phones registered to SPA9000 to call out on POTS?
Related Information

Introduction


This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products.

Q. How can I set-up the SPA3000 as PSTN Gateway of SPA9000 to make all calls go to Auto Attendant and allow phones registered to SPA9000 to call out on POTS?

A.

Calls from POTS can automatically go to Auto Attendant and any phone registered to SPA9000 can call out on POTS by dialing the User-ID on the SPA3000's PSTN Line (103).

Note: This article assumes: Internet ------SPA9000 (with analog phone on FXS 1-------SWITCH-------SPA IP phone and SPA-3000 (PSTN Line connected to FXO port).

Step 1:
Register Line 1 of SPA9000 to VoIP (Optional). Access the SPA9000's web-based setup page, and click Admin Login then advanced.

Step 2:
Click Voice then Line 1. Scroll down and under Subscriber Information, provide the necessary information for the User ID and Password fields. Under Proxy and Registration, look for Proxy, and enter the required proxy value given by your VOIP provider. Scroll down to the bottom, and click in order to save your settings.

Step 3:
Click Line 2 and set Line 2 of the SPA9000 with a User-ID (ie:103) then click Submit All Changes.

Step 4:
Access the SPA3000's web-based setup page. Click Admin Login, then advanced.

Step 5:
Click PSTN Line.

Step 6:
Scroll down and under Proxy and Registration, manually register the PSTN Line of SPA3000 to SPA9000.

Proxy: 192.168.0.1:6060 (SPA9000 Proxy Network Interface is set to LAN)
User-ID: 102 (example only)

Step 7:
Scroll down and under FXO Timer Values (sec), enter "0" in the PSTN Ring Thru CWT Delay and PSTN Answer Delay fields.

Step 8:
Under PSTN-To-VoIP Gateway Setup, look for PSTN Ring Thru Line 1 and select No from the drop down menu. Enter "2" in the PSTN Caller Default DP field.

Step 9:
Scroll up, look for Dial Plans, and enter "(S0<:103>)" in the Dial Plan 2 field. Click Submit All Changes in order to save your settings.

Step 10:

Click .


Related Information

Updated: Dec 12, 2008
Document ID: 108762