Enabling the Remote Management Feature on the SPA3102
How to enable the remote management feature of SPA3102?
This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products.
Q. How to enable the remote management feature of SPA3102?
In order to enable the remote management on the SPA3102, complete the steps outlined in this document.
Enabling Remote Management
Connect the computer to the LAN port of the SPA3102 and access the SPA400's web-based setup page. For instructions, click here.
When the SPA's web-based setup page appears, click Admin Login then advanced.
Click WAN Setup under Router, then look for Enable WAN Web Server and select yes. The default WAN Web Server Port is set to "80 " on the web-based setup page of SPA-3102.
Note: After saving the settings, the user can access the SPA3102 web-based setup page remotely using "http://wanipaddressofspa3102:80" on the Internet Explorer's Address bar.
Was this Document Helpful?
This Document Applies to These Products
© 2015 Cisco and/or its affiliates. All rights reserved.