Guest

Cisco Small Business Voice Gateways and ATAs

Setting the SPA2100 to bridge mode

Document ID: 108806

Updated: Dec 12, 2008

   Print

Contents

Introduction
How do I set the SPA2100 to bridge mode?
Related Information

Introduction


This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products.

Q. How do I set the SPA2100 to bridge mode?

A.

Setting the SPA2100 to bridge mode

There are two ways to configure the unit in bridge mode.

  • Setting the SPA3102 to bridge mode using the IVR
  • Setting the SPA3102 to bridge mode using the setup page

Setting the SPA2100 to bridge mode using the IVR

In order to set-up SPA2100 to bridge mode using the IVR press **** 201, press 1 to enable and 0 to disable the router functionality of the unit.

Setting the SPA2100 to Bridge Mode Using the Setup Page

In order to set-up the SPA2100 to bridge mode using the web-based setup page, complete these steps:

Step 1:
Access the SPA2100's web-based interface. For instructions, click here.

Step 2:
When the SPA2100's web-based setup page appears, click Admin Login then advanced on the upper right-hand corner.

Step 3:
Click Lan Setup and change Enable DHCP Server to no.

Step 4:

Click .

 

Related Information

Updated: Dec 12, 2008
Document ID: 108806